Good question, Dave. The easiest way is to match the RVpaws kit to your jack leg or leveling system. For example, there are specific kits for the brands and lineups out there: Standard 2" round jack leg = #RV57FR Standard 2" square jack leg…
Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…
Hey Dennis! If your fifth wheel uses standard 2" square leveling jack legs, the RVpaws articulating jack pads #RV24FR is the correct kit. If the legs are standard 2" round instead, you’d use #RV57FR. If you actually have Lippert Titan or…
Good question, Mark. The RVpaws V2 pads are definitely stronger than most OEM setups. They are built from 1/4" plate steel with 6 gussets, so they’re a nice upgrade over thinner factory-style feet that have about 1/8" thick plate. The right…
Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…
Hey Jerry, does the LED still light up on the front of the Mighty Cord SurgeMinder Surge Protector and Circuit Tester #SU39SR? If it was actually overloaded it would have damaged the internals of it and it wouldn't work as a surge protector any…
Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…
Hi Jeff! To be perfectly honest, there is no difference between them. The Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness #RED72CR comes to us already put together to fit your 2017 Toyota Tacoma, whereas the Redarc Tow-Pro Liberty Brake…
Hey Scott. The Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump like item #FR97TQ in black or item #FR67TQ in white are only available in 18K btu capacities. The Chill Cube uses variable-speed technology, which allows it to reduce…
Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…
Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
Your internet site is very well organized and easy to use...My order was shipped very promptly and included everything I ordered...All in all this was a simple procedure for what can be a complicated order. I would use your company again or recommend you to others. Your selection was broad and your prices fair.
Robert
Bloomington, IL
RV Interior Lights with LED Pendant Lighting
Freshen up your rig with a pendant light that uses LED light for bright, efficient 12V illumination. Choose the hang length and look you want, then compare canopy size and mounting-hole spacing to your old fixture to make install smoother; some work with a compatible dimmer. Pendant fixtures don't articulate, so they aren't a fit for sloped ceilings.
Sometimes. Some LED pendant lights use a board with LEDs that isn't replaceable, while others take replaceable 12V bulbs. Check whether the fixture uses a standard 12V bulb or an integrated LED panel. Before final install, make sure any bulb seats and locks securely in the fixture.
No. RV pendant lights don't have a way to swing and will sit at an awkward angle on a sloped ceiling. For a sloped area, use a fixed light like a puck instead of an LED pendant light.
Measure from the ceiling to where you want the bottom of the shade. Check the overall length from the mounting flange to the bottom of the globe. Watch slide-out and headroom clearance—some pendants don't hang as low as the originals. If you need more or less drop, verify the rod or chain length options on the LED pendant light.
Install is typically straightforward, but compare canopy size and screw-hole diameter to your old fixture. You may need different screws or to reuse a base if sizes differ. Confirm canopy diameter ahead of time. Inspect for bent shades or a dented mounting base before mounting to save time.
Yes, LED pendant lights are made for RV 12V setups and can be wired to your wall switch. Many can be dimmed when paired with a compatible 12V dimmer. Confirm the light is rated 12V and that the LED pendant light is listed as dimmable before you hook up a dimmer.
Filters
