2008 Keystone Sprinter Travel Trailer Blind Spot Detection

Hey David, The LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane #344270KIT30 does need to be installed on a clean surface per the installation instructions: - Make sure the deck is clear of all debris. NOTE: XTRM PLY membrane must be…

Hey Dave, we have the 96 inch long cable part #TC96PB you can use with the Valterra Cable Drain Valve #VAL72RB that you referenced.

Rodney, you aren't the first and likely not the last to want this, but unfortunately there is no way to tie in your Furrion RV camera system to your Ford F-250. Furrion's camera systems are only compatible with their monitors like #FR97FR, so…

If you are looking for a suspension lift for your Forest River Wildwood X-Lite 273QBXL due to its low ride height the best option is absolutely the Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00. The reason is this will give you the…

Hey Bryan, I would go with the Kenda Karrier KR53 part #KE72EV to use as a spare on your 2012 Jayco Jay Flight travel trailer. Its the correct size wheel and tire that you need, it's the Load Range D you need, and also is the best priced option…

Hello Rocky, thanks for reaching out. If your new leaf springs do not have as much of an arch as the old springs they are definitely not going to help your situation if your tires are already rubbing on the fenders. What we would usually do here is…

Hi Stephen, If your weight distribution hitch is overrated for the tongue weight of the trailer then it will over-distribute the weight and start lifting both the trailer tongue and rear of the tow vehicle up. You'll notice handling issues while…

Hello Bob, thanks for reaching out. Unfortunately there is not a camera available that is compatible with the Voyager WVOS54 monitor. This is an older first gen camera system and they have been discontinued so we do not have a compatible camera. The…

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

For your 1-1/2" piping, you can use the Valterra RV Sewer Spigot with Flange #T1006-1. This spigot connects to your sewer pipe to your grey water waste valve by sliding over your 1-1/2" pipe. Additionally, to solidify these two components,…

We do offer a 1-1/2 inch spigot that has a flange, it can be found with part #T1006-1. You will want to make sure to secure it with ABS Solvent Bond #A05-0303 which is sold separately.

The 5" diameter thin wall drain pipe you pair with the Valterra RV Sewer Hose Storage Hatch w/ Lock, White #D04-0471VP or Black #D04-0471BKVP, is something that needs to be picked up from your local hardware or home improvement store.