What Kind Of Bolt Should Go At The Rear Of A Slipper Spring?
Updated 04/15/2026 | Published 04/11/2026
Question:
What is the correct bolt for a leaf spring slipper side? Same as eye bolt?
asked by: Scott H
Expert Reply:
Hi Scott!
You are absolutely correct. The same standard bolt would be used on both sides of the leaf spring, even when it is a slipper spring. The only exception to that would be if it was a wet bolt, as that would just leak grease everywhere and wouldn't really serve any purpose.
The ABS Fasteners Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long # 166079 will work perfectly.
What kind of trailer are you wanting to install this on? And are you switching to slipper springs from double eye?
Product Page this Question was Asked From
Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long
- Trailer Suspension Parts
- Suspension Bolts
- Camper
- Car Hauler
- Utility Trailer
- 9/16 Inch Diameter
- 3-1/2 Inch Long
- ABS Fasteners
more information >
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Leaf Spring for a Dexter 072-079-01 Leaf Spring
- Article: Trailer Wiring Diagrams
- Q&A: Installation of Slipper Spring with Open Eye End
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Looking For Brakes And Hubs For 10K American Axles
- Q&A: What Are the Dimensions of the Spring-Eye Bolt with Locknut for Slipper Springs
- Q&A: How to Measure For Replacement Slipper Spring Equalizer For Gooseneck Trailer
- Q&A: Replacement For 11-1/2" Slipper Spring Equalizer
- Q&A: How to Measure Trailer Leaf Spring to Find Correct Replacement
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure a Trailer Axle