Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at part number 464600 this is the wire frame clip. This clip is made of spring steel with a black enamel finish that's going to be used to secure one or more wires to the frame or panel surface of your trailer. You can see right here I have it on piece of angle iron. The piece of iron that I'm using today is going to be a little bit thinner than probably what your trailer frame's made of so it doesn't provide as tight of a fit. This is spring steel, so it's going to fit a variety of widths of trailer frames or panel surfaces and a very versatile clip. It's going to get the job done.
These are going to be designed to hold your wires up and out of the way making sure they don't dangle loose. It's going to help take out any slack in your wiring keeping them up and out of the way, safe and secure from any type of damage or harm. Very simple installation. The overall length is about one and five-eighths of an inch. The width from edge to edge is going to measure about a half inch and then the wire width capacity measuring from inside edge to inside edge is going to measure about three-eights of an inch. I have some 16 gauge bonded wire.
This is going to be wiring for a standard 4-way flat connector. Simply going to place it in there. The clip's going to feature a couple teeth on it. That's really going to help it dig into and hold its place on the trailer frame or panel surface. Once you have your wiring in there, simply just place the clip over the frame and you can see there it gives us plenty of room for our wiring to move.
Albeit it's still going to hold it in place so we don't have to worry about it dangling or very much slack in our wiring, it really cleans up our installation. That's going to do it for our review of part number 464600. This is the wire frame clip. .
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews

Dave P.
8/25/2015
Theyre working out wellin a bag in my garage. Theyre way too big for my fairly heavy duty trailer. I tried them and they are too big to snugly pinch the steel frame.

Jd
3/17/2015
1 year later and all is well with my clips even after highway driving and some very bumpy red clay roads.Great product

Gilbert
5/31/2021
Wonderful

Rich A.
8/17/2015
Everything is still working fine.
Do you have a question about this Electrical Tool?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.




Craig D.
8/7/2015
The clips are still attached to the trailer and the harness is still in place. No problems with the product!