Size of Trailer Wire Mounting Clip
Updated 05/01/2020 | Published 06/19/2009
Question:
What is the size of this clip? As you have not listed length / width, max wire capacity, frame depth etc. Thank you.
asked by: Brian S
0
Expert Reply:
The height of this clip is 1-1/2 inches, width is 1/2 inch, width for wire capacity is 3/8 inch and the frame depth is 5/16 of an inch. Constructed of spring steel and has a black enamel finish.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Difference Between SWC9041-1, SWC9042-1 and 464600 Trailer Frame Wire Clips
- Q&A: How to Install Ground Wire To Trailer Connector on Utility Trailer
- Q&A: Wire Size Used to Install MaxxFan Deluxe Roof Vent w/12V Fan & Thermostat MA00-05100K
- Q&A: Brake Lines for Boat Trailer In Salt Water
- Q&A: Clips and Clamps to Attach Wires and Wiring Harnesses to the Bottom of a Trailer Frame
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: Recommended Trailer Wiring To Charge Battery And Use Solar Panels
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
J.p
4/29/2020
When you say frame depth is 5/16 are you referring to the thickness of the metal it would attach too? I have 1/4 thick angle iron that I need to attach to, will this work?