Tips For Securing Duplex Wiring Under a 2016 Ford Escape
Updated 02/17/2026 | Published 06/13/2024
Products Featured in This Question
Question:
Are there any special clips to purchase or a special way of routing the 10 gauge duplex between front and back on a 2016 Ford Escape? there is no long plastic shield to snake it under on the 2016 vs the 2017 illustrated in the video. The flooring underside there just has undercoating. 2016 SE 2.0 w tow pkg. George
asked by: George M
Expert Reply:
Typically when running the duplex wiring in the 7-Way Install Kit # ETBC7 we would recommend using either Frame Clips # 464600 or Cable Ties # DW05726-10. The clips can be used on openings while the cable ties allow you to secure the wiring to other wiring or brake lines.
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Wiring and Brake Controller Set up For a 2003 Ford Van E350
- Q&A: Comparing the Universal Installation Kit # ETBC7 and the 7-Way RV Upgrade Kit # ETBC7L
- Q&A: Hitch, Weight Distribution and Brake Controller Recommendations for a 2017 Toyota Sienna XLE
- Q&A: Recommended Brake Controller and Wiring Harness for a 2006 Dodge Ram w/a Factory 4-Way
Jerred H.
2/17/2026
Hey George, how did routing the 10-gauge duplex go on your Escape using the frame clips or cable ties? Knowing what worked best for you could really help others wiring the same setup.