Rub marks, squeaks, or crooked loading? A swivel bolster lets you pivot your bunk so it sits flush to your hull. You set the height, it spreads the boat's contact, and you'll load your boat smoother while protecting it's finish.
Swivel bolster brackets let you adjust your bunk boards to where they should be, so the hull sits right and loading feels smooth. The 2-3/4" vertical slot gives you the wiggle room to dial in bunk height for your boat, and the non-slip dimples bite into the board to prevent movement and boost load capacity. The longer 12" footprint holds the bunk steady, so it doesn't wander after a few launches or a long haul. Hot-dip galvanizing means it can live on a wet trailer without turning into a rusty mess, and the hardware will still back off when you need to service your trailer bunks.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone. Steve here with etrailer.com. Today, we're taking a look together at our tie down swivel bolster bracket for bunk boards. This one is gonna be 12 inches long or tall, and this is gonna be a great option for attaching those bunk boards, as you already know, and then you can select the pitch, the angle on those, and then obviously this would be tightened up at the angle that you need it at whenever you've got your bunk boards installed on the top. Now, what's nice about this, other than the fact that it's been hot dipped, it's galvanized steel, so it's not gonna corrode obviously. You got a lot of dimples that they've kind of punched out when they built this, and those are gonna help hold onto the frame whenever you have it bolted in place on your boat.
And then obviously, you've got those 2 3/4" long slots to help let you rise and lower it precisely where you need it for your setup. Now again, this is a 12 inch long option. We sell these in 10 and eight inches as well. If you don't need something quite this big, you can check them out separately. Again, this is a great option for you.
You're gonna get quantity one. This is the tie down swivel bolster bracket, 12 inches. I'm Steven. Thanks for watching.
Ratings & Reviews
Right on time
Do you have a question about this Boat Trailer Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.