Can an Awning Switch Be Added Outside on a Trailer?

Question

Question:

when I order this product is it possible to buy an extra switch so I can wire one switch inside and one outside in the pass-through? Would both switches work separately? Thanks

asked by: Tim R

0

Expert Reply:

There should be no issue wiring a separate switch on the outside of your trailer. However, there won't be a way to do this without hardwiring the # LC285500 into your current switch.

I should also mention that this isn't typically used outside, so it is not weather proof. If you do end up mounting it outside, it should be done somewhere protected from the rain.

expert reply by: Lazer S

0

Answer 1

Hey Dan, for your 2024 Ford F-350 that has the OEM pucks the correct Pullrite sliding hitch you need is the part #PUL73RR. The #PUL63RR fits the standard above bed fifth wheel rails that are 22 inches apart on center. What fifth wheel do you have?

view full answer...

Answer 2

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 3

Hey Jason, thanks for getting in touch. For a Dometic AC unit I recommend the SoftStartRV Soft Start for Single Zone Air Conditioner Setup #SSR54FR. This is a universal soft start, and it is known to work with the Dometic units. The chart below shows…

view full answer...

Answer 4

Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…

view full answer...

Answer 5

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 6

To power the Solera Smart Arm 12V Power RV Awning #LC517486 you simply will connect your white power wire with the white wire from the switch and run that to the positive terminal of the battery inline with the supplied 15amp fuse. From here, connect…

view full answer...

Answer 7

Hey Ron, good to hear from you! How long are your current U-Bolts? The U-Bolt Kit #APUBR-8 could potentially work as it has 7" long U-Bolts, but it really boils down to what you currently have. For something longer we have the MORryde U-Bolt Kit…

view full answer...

Answer 8

All of our trailer spindles are shown on the linked page, but none of these has a stub end to fit 2 x 3-inch tubing. All are either round like #TRU74FR or square like #TRU47FR. For a fabrication project like yours a better solution may be a bolt-on…

view full answer...

Answer 9

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

view full answer...

Answer 10

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

view full answer...

Can an Awning Switch Be Added Outside on a Trailer?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching