Will the Third Brake Light On Camper Shell Blink When Turning.

Question

Question:

Hello, how can I wire the 3rd brake light on my truck camper shell WITHOUT it blinking when using either turn signal. Any help is appreciated!

asked by: Adam M

0

Expert Reply:

In order to successfully wire in a third brake light on a camper shell you need to identify first if the taillights on the vehicle are combined or separate meaning, are the stop and turn signals on the same circuit or separate. If they're separate then you can just splice into the stop light switch wire and the third brake light won't blink. If they're combined then you need the Third Brake Light Module part # PP20-702 to stop the third brake light from blinking with the turn signal.

expert reply by: Conner L

0

Answer 1

The 3rd Brake Light Logic Module part #PP20-702 is the solution to your problem. It's very cost effective and easy to install. The module simply takes the stop/turn signal from the vehicle whether that's the right or left side and separates…

view full answer...

Answer 2

Actually, the correct part to wire in a truck bed cap's third brake light is the converter #PP20-702. Since your 2019 Ram's turn signals and brake lights run on one circuit this separates them so the light on the cap functions with just the…

view full answer...

Answer 3

I spoke to my contact at Curt about the Vehicle to Vehicle Tail Light Converter part #C56196. They informed me that only one side (right side stop/tail or left side stop/tail) of the two wire system needs to be attached to the converter box in order…

view full answer...

Answer 4

According to the owner's manual a 2014 Ford F-150 has the following fuses or relays for a trailer (the numbers will be their position in the power distribution box): - 6: Trailer tow park lamp - 9: Trailer tow battery charger - 17: Trailer brake…

view full answer...

Answer 5

Brake controller wiring harness #22292 plugs into the built-in connector beneath your vehicle's dashboard. To access this connector, first locate the instrument cluster finish panel in the center of your dash, near the driver's side.…

view full answer...

Answer 6

To fix this issue, you're just going to need to install the: -3rd Brake Light Logic Module #PP20-702. This will separate the third brake light and your turn signal lights to alleviate the flashing. Attached is a product overview video for you to…

view full answer...

Answer 7

Since the Yakima CoreBar #Y00421 does not have a t-slot to accept the standard load stops like #753-3761, and due to its shape the LoadStop Brackets for Yakima Round Crossbars #Y05000 won't work either, leaving you with no compatible option. In…

view full answer...

Answer 8

In order to power the third brake light on a truck bed cap you will need the Pacer Performance 3rd Brake Light Logic Module part #PP20-702. The reason you need the module is that the brake/turn signal circuits and trailer lighting circuits are…

view full answer...

Answer 9

The 20x8.00-10 is an old way of measuring and the new size that you need is 205/65-10. This would be a very close match and fits your 10 inch wheel just fine. The part #AM1HP56 would be a great solution as this is the correct size and it has a…

view full answer...

Answer 10

Since the trailer connector on your 2013 Ford F-150 is no longer sending power to the turn signal circuits on your trailer you will need to replace fuse #73. This 20-amp fuse is located in the engine bay fuse box and is what sends power to the…

view full answer...

Answer 11

The pictures you are referring to are actually for older Silverado and Sierra pickups. I am not aware of any special wiring near the rear of your 2018 GMC Sierra 2500 but you can easily isolate the brake signal by using the 3rd Brake Light Logic…

view full answer...

Answer 12

The Pacer Performance 3rd Brake Light Logic Module #PP20-702 referenced in your question is a universal item that can simply be used to filter out the turn signal inputs for installation of a 3rd brake light (so the light doesn't illuminate with…

view full answer...

Will the Third Brake Light On Camper Shell Blink When Turning.

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching