Preferred Method of Grounding Trailer Lighting Circuits
Question:
Hello. On ST8RB and ST9RB and others that ground itself via bolts, would it be better to attach white ground wire on the mounting stud in lights and run it forward to tong if trailer, in this case, wire junction box, would it be better and to make sure its grounded as a safeguard? Would the extra ground wire wouldnt hurt, other than making sure its grounded? and prevent me from constantly replacing fuses on truck side, which narrowed down to lack of positive ground in trailer side
asked by: Robert
Expert Reply:
Running a direct ground up to the trailer tongue or junction box would certainly work, but the only time I'd see that as being necessary is if the lamps were connected to a non metallic structure or a metallic structure that wasn't directly connected to the trailer frame. If the lamps aren't connected to a metal structure in direct contact with the trailer frame, you can use a short length of # DW02359-1 wire with a # DW05702-1 ring terminal on each end to serve as a jumper wire that joins the mounting stud of the lamp to the trailer frame.
When the lamps are installed on metal that's in contact with the trailer frame, the circuit is using the metal trailer frame itself as a ground circuit, so running a separate ground circuit isn't really necessary. If the trailer in question has a tilting tongue or a tilt bed, sometimes the pivot point between the moving and stationary portion of the trailer becomes worn, leading to a poor ground connection. In that case, using a jumper to join the moving to the stationary part of the trailer will fix the issue.
Products Referenced in This Question
Ring Terminal -16-14 Gauge - 1/4" Ring ID - Qty. 1
- Wiring
- Wire Connectors
- Ring Terminals
- 1/4 Inch Diameter
- 16-14 Gauge
- Deka
more information >
Combination Trailer Tail Light - 7 Function - Incandescent - Square - Red Lens - Driver Side
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 5-3/16L x 4-9/16W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
Optronics Combination Trailer Tail Light - 6 Function - Incandescent - Red Lens - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 5-5/16L x 4-9/16W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Shop: Brake Controller
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: diode
- Video: Review of Optronics Trailer Lights - LED Tail Lights - OPT94KB
- Shop: 16 Gauge Primary Wire - White - Per Foot
- Search Results: vents
- Search Results: roof vents
- Q&A: Trailer Coupler Repair Kit for Coleman Bayside Popup Camper
- Shop: Dexter Trailer Hub and Drum Assembly for 2,000-lb E-Z Lube Axles - 7" Diameter - 5 on 4-1/2
- Shop: Easy Grease Trailer Hub and Drum Assembly for 2K Axles - 7" - 5 on 4-1/2 - L44643 - Pre-Greased
- Article: How to Hitch and Lock a Trailer
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Dexter Electric Trailer Brake Assembly - 7" - Left Hand - - 2,000-lbs to 2,200-lbs
- Search Results: lynx leveler
- Search Results: 7" drum
- Search Results: trailer hitch ball mount
- Shop: Redarc Tow-Pro Elite Brake Controller for Tekonsha Harness - Off-Road Mode - Proportional
- Q&A: Recommended Trailer Wheel and Tire For a 1994 Coleman Pioneer Arcadia With a Higher Weight Capacity
- Q&A: Replacement Coupler Repair Latch For A Coleman Casa Grande Popup Trailer
- Q&A: Which Bearing Buddy Is Compatible With a 1999 Coleman Sea Pine Trailer?
- Q&A: Repair Kit for A-Frame Coupler on Coleman Pop-Up Camper
- Q&A: Replacement 7-Inch Hub/Drum for 1993 Coleman Cape Cod Pop-Up Tent Trailer
- Q&A: How To Add Electric Brakes to a 1995 Coleman Stony Creek Trailer
- Search Results: tekonsha
- Shop: Nosing Edge Trim - Enclosed Trailer - 93-1/2" Long x 1" Tall x 3/16" Deep - Aluminum
- Shop: Vehicle Lights
on Trailer Lights
