Hello Chris, For your 2022 Grand Design Reflection 31MB 5th wheel with the MORryde CRE 3000 and wet bolt kit, the right crossmember brace is the MORryde X-Factor Crossmember #MR33WR. It helps stabilize your suspension, reduces stress by up to 94%,…
We do have a MORryde X-Factor Crossmember that is compatible with the CRE. However, the #MR99ZR you were looking at only works with the LRE, RE, or TRE suspension systems. What you need instead is the #MR33WR. This is compatible with CRE, SRE, or…
Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
For hubs that have 1/2" studs, like the Easy Grease Trailer Hub and Drum Assembly for 5.2K - 7K Axles #AKHD-865-7-2-EZ-K you're looking at, you don't want to exceed 120 ft-lbs as that's the most torque this stud size can handle.…
The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…
I have attached a sheet which shows the torque specs for wheels you can use when putting a tire and wheel. For 1/2" wheel bolts on a 13" aluminum wheel the torque is 75-85 ft.-lb. For lug nuts you can use the Lionshead Trailer Wheel Lug Nut…
Hello Chris, Great question! To be honest, I could not find anything that was listed different so I reached out the manufacturer to get the answer. The difference between the two is one has a check valve and the other is just a pass through. The…
The Flow Max DS-01233-M was not recalled that I can find, but it is a model that is no longer offered. If yours is not working there is a replacement with the Flow Max RV Fresh Water Pump #LC689052. I have added a link to the instructions and a video…
I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…
Blane, what you're looking for is the 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles #DX74XR. This spring has a 4k capacity, will work with 8k axles, has 1 3/4" wide leaves. You'll notice that these springs are a bit shorter, but…
Yes the Brophy Rigid Mount Spare Tire Carrier #BR56VR that you referenced would fit your bumper that is 4 inch square, has enough weight capacity, and can work with your bolt pattern.
For two Lippert slam latch replacements, you can use the Lippert Slam Latch for RV Doors #LC54PJ. These slam latches are going to require a key to unlock and lock it as we do not have any options that don't have a lock. What you could do also if…
