2009 Chevrolet Colorado Trailer Hitch
2009 Chevrolet Colorado Trailer Wiring
2009 Chevrolet Colorado Brake Controller
2009 Chevrolet Colorado Front Mount Hitch
2009 Chevrolet Colorado Towing Mirrors
2009 Chevrolet Colorado Base Plate for Tow Bar
2009 Chevrolet Colorado Vehicle Tow Bar Brake System
2009 Chevrolet Colorado Vehicle Tow Bar Wiring
2009 Chevrolet Colorado Roof Rack
2009 Chevrolet Colorado Tool Box
2009 Chevrolet Colorado Ladder Rack
2009 Chevrolet Colorado Vehicle Cargo Control
2009 Chevrolet Colorado Truck Bed Sliding Tray
2009 Chevrolet Colorado Truck Bed Bike Rack
2009 Chevrolet Colorado Air Filter
2009 Chevrolet Colorado Suspension Enhancement
2009 Chevrolet Colorado Transmission Cooler
2009 Chevrolet Colorado Performance Chip Tuners
2009 Chevrolet Colorado Vehicle Lights
2009 Chevrolet Colorado Tire Chains
2009 Chevrolet Colorado Fluid Filters
2009 Chevrolet Colorado Vehicle Sway Bars
2009 Chevrolet Colorado Catalytic Converters
2009 Chevrolet Colorado Vehicle Snow Plows
2009 Chevrolet Colorado Salt Spreader
2009 Chevrolet Colorado Vehicle Engine Heaters
2009 Chevrolet Colorado Off Road Lights
2009 Chevrolet Colorado Radiator Fan
2009 Chevrolet Colorado Floor Mats
2009 Chevrolet Colorado Tonneau Cover
2009 Chevrolet Colorado Nerf Bars - Running Boards
2009 Chevrolet Colorado Trim Kits
2009 Chevrolet Colorado Vehicle Covers
2009 Chevrolet Colorado Grille
2009 Chevrolet Colorado Grille Guard
2009 Chevrolet Colorado Bug Shield
2009 Chevrolet Colorado Side Window Vents
2009 Chevrolet Colorado Truck Bed Mat
2009 Chevrolet Colorado Mud Flaps
2009 Chevrolet Colorado Truck Tailgate Lock
2009 Chevrolet Colorado Vehicle Tent
2009 Chevrolet Colorado Vehicle Seat Covers
2009 Chevrolet Colorado Replacement Mirrors
2009 Chevrolet Colorado Windshield Wiper Blades
2009 Chevrolet Colorado Windshield Covers
2009 Chevrolet Colorado Vehicle Air Mattress
Videos
for Chevrolet Colorado Owners
Help Articles
Expert Answers
there are actually 5 key parts needed to flat tow any vehicle: base plates, tow bar, safety cables, lighting, and supplemental braking. The base plates provide a safe and secure attachment point for the tow bar on the vehicle. For your 2006 Chevy…
Normally a bumper is rated at about 3500 lbs towing capacity. It is usually stamped somewhere on the bumper or possibly on a sticker. A frame mounted hitch is going to have more capacity for towing due to how it is installed. Also, most trailers will…
The seals that you would need to replace your AL-KO 1536852 seals are the TruRyde Grease / Oil Seals 10-10 (Pair) - Double Lip Seals #RG06-090. They have an inner diameter of 2.125", an outer diameter of 3.376", and are used for 5,200 lb -…
Dexter part 10-41 is a grease seal for a mobile home utility hub. It has a specified inside diameter of 1.938-inches and an outside diameter of 2.523-inches. The nearest match we offer is the Redline part #10-40 which is a single-lip seal that has…
I pulled up the owners manual of your 2010 Chevy Colorado and it has the fuses for the trailer wiring in the same location as the picture of the 2012 that you mentioned. You might have to dig around a bit lower to see if you can find it as it should…
If the 12-volt pin on your trailer connector isn't working, you've got a missing or blown fuse or the wiring connection at the fuse box under the hood wasn't finalized. You're looking for a 40 amp fuse, located in position #68 in the…
Actually to install a 4-way in your 2007 Chevy Colorado all you would need is the part #118301 that plugs right in to factory wiring on your truck. There would be no need to hardwire anything at all. Also, since your truck has separate turn signals…
When a 7-way connector was installed on your Colorado, a converter should have been included because the vehicle has separate lighting meaning the brake signal and turn signals are sent along separate wires. It sounds like the wiring kit was not…
Typically what people do to mount the propane tank covers like the part #CAM40542 is to use a bungee cord like #EM06755 to secure it below the tanks. The cover has two tabs on the bottom of it that allow for the hooks of the strap to be attached to…
In order to actuate the trailer brakes, you'd need a brake controller installed in the vehicle and a 6 or 7-way trailer connector. A 4 pole flat wiring harness like the #18002 you'd looked at carries 4 circuits- right turn/brake lamp, left…
It sounds like you are looking for the 1-1/4" to 2" adapter for a Rhode Gear Bike Rack and if that's the case we have just what you need, the Replacement Hardware for Rhode Gear Highway Bike Carriers part #RG890247. If this was not what…
The lug nut torque will depend of the diameter of your wheel studs and the construction of your wheels. • For a steel wheel and a 1/2 inch stud, torque the lug nut to 90-120 foot lbs • For a steel wheel and a 9/16 inch stud, torque to 120-140 foot…