2002 Nissan Frontier Truck Bed Sliding Tray

Hey Scott, the correct factory mount install kit for a BedSlide for a 2026 GMC Sierra 3500 would be the part #BE45UV. Do you have a BedSlide already?

Hi Kristian, great question! The etrailer Anti-Rattle Hitch Collar, part #e55YV, works by taking the slack out between your hitch receiver and the shank of your ball mount or hitch-mounted accessory. It clamps around the outside lip of your 2-1/2…

Hey Scott! The etrailer Anti-Rattle Hitch Collar #e55YV is rated for up to 10,000 lbs gross trailer weight and won't reduce the capacity of a properly matched towing setup. As always, your actual towing capacity is determined by the lowest-rated…

Hey Mike, congratulations on the new truck! You can definitely use the two together. The Curt StowPro 2-Ball Mount #C34FR53HY uses a standard 2-1/2" shank, making it a great match for our etrailer Anti-Rattle Hitch Collar #e55YV. It installs…

Hey Greg! The etrailer Anti-Rattle Hitch Collar for 2.5" Hitch Receivers #e55YV is not compatible with a weight distribution hitch. This is really the only restriction for our anti-rattle. If you need an anti-rattle for a weight distribution…

Good question, Aaron. Since your main detail is the GM MultiPro tailgate, I’d be careful here. The B&W Tow & Stow for 2-1/2" receivers #BWTS20066BMP is specifically listed as compatible with the GM MultiPro tailgate, so if tailgate…

Hi Roy, Yes, the 30 Amp Portable Power Watchdog #HU32VR will protect your RV from sustained low voltage as well as power spikes and high voltage. If the incoming voltage drops to 104 volts or below, or climbs to 132 volts or higher, the watchdog face…

Hey Raphael, it takes about 15-30 minutes roughly. It's not hard at all and uses basic tools (9/16" socket/wrench and tape measure). A battery-operated drill could definitely speed up the process. It's just a one person install. And yes,…

Hey Jacob, thanks for reaching out. The Westin Custom Fit Truck Bed Mat #50-6405 weighs approximately 45 lbs. It'll fit the 2017-2026 Ford F-250 and F-350 with the 6-3/4' bed. What do you usually haul in your truck bed?

Hey Victor, welcome back. There are no custom fit aftermarket hitches available for a 2010 Chevy Suburban 2500. The factory hitch on your SUV was built into the rear bumper so none of our vendors made a replacement for it. To add a class V hitch…

Hey Richard, yes the Blue Ox Apollo part number BX7470P is the same as our part #BLU43QV. We change the part number just to organize it better in our system. This tow bar will also work with both base plate kits you mentioned part #BX1633 and…

Hey Max. To attach the T-One Vehicle Wiring Harness item #118648 to your new Curt Hitch item #C13343, you'll need the No-Drill Mount Bracket item #18136 and the Mounting Bracket 4-Pole Flat item #18144. The No-Drill Mount Bracket item #18136 uses…