Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The vertical poles of the Yakima SlimShady part #Y36VR are height adjustable from 4 foot to 7 foot in height.
view full answer...The Dexter "8-256" is a hub assembly that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in a few different bolt patterns therefore you would need to confirm your bolt pattern using the attached help…
view full answer...In order to flat tow your 2018 Ram 2500 behind an RV you will need a base plate kit, tow bar, safety cables, a lighting solution, a supplemental braking system, and most likely a high-low adapter. I also recommend checking your truck's…
view full answer...We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…
view full answer...Since heat rises I would at the very least put a set of the Trailer Vents #HMAV2-AVT2 near the top of the trailer to get the hottest air of the trailer out. What you could do for maximum air flow in your trailer is have a set facing forward in the…
view full answer...The Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88299 feature air springs that can be adjusted from 5 psi to 100 psi. There isn't a specific inflation level that is recommend for your 13,000 pound 5th Wheel Trailer because it will…
view full answer...Yes, it is true that most types of 5th wheel to gooseneck adapters will cause stresses on the trailer's frame and in some instances may actually void the warranty on the trailer frame. However, there is one type of 5th wheel to gooseneck adapter…
view full answer...Fifth wheel hitch towing setups actually don't require safety chains by law and in general people do not add them on. It turns out that the only time safety chains are required is if there's a hitch ball used as the attachment point and not a…
view full answer...From what I have found, the ALKO hub and drum assembly you have is for 7,000 lb axles. I believe the Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 12" - 8 on 6-1/2 #8-219-4UC3 will work as a replacement. This has the same…
view full answer...The outer diameter of the upper tube of the Andersen Ultimate Offset part #AM3140 is 4 inches.
view full answer...The tandem axle lift kit part #RR23QX that you referenced would be the easiest and best solution to gain 2 inches of height on your trailer suspension. Going with a new 7k leaf spring might help little bit like with the part #e64SR but this is a 6…
view full answer...If you have a gooseneck trailer then we do have an option for your trailer side with the B&W Extend-A-Goose Gooseneck Coupler #BWTEXA4200. It has a 10" offset and has an outer diameter of 4". For something that site between the hitch…
view full answer...