Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Rodney, it sounds like you've done your homework! That MoRryde set up you referenced is definitely going to upgrade your Dutchman's suspension and make towing it more comfortable. You'll want to take two measurements before ordering…
view full answer...Hey Luis, We can answer both your questions in one as yes, you can change from the CRE3000 to AllTrek 4000, and it's definitely an upgrade worth making, as the AllTrek 4000 is better in a couple ways from the CRE3000. The first is the 4000 is…
view full answer...One end of the umbilical cord that comes with the Brake Buddy Stealth Supplemental Braking System part #HM39530 is a 7-blade round connection that connects to motor home's 7-way plug. The other end is a 7-flat connector that plugs into the…
view full answer...In regards tot he roof thickness, the MaxxFan Dome Plus vent does require a 1 inch thick roof at the minimum. So you would need to build up the roof of your camper where the vent installs to have at least 1 inch of thickness. In regards to the…
view full answer...Good morning, Don. The 3/4" wide butyl tape is exactly what we recommend for installing a roof vent such as the MaxxFan #MA00-07000K. We actually sell a roof vent install kit part #344270KITW that comes with sealant, screws and a 30' roll of…
view full answer...Lippert is deeply in the pockets of pretty much every trailer/motorhome manufacturer so they most likely installed the repeater block so that you'd be more inclined to purchase their sensors over other brands. The Tire Linc OneControl TPMS w/…
view full answer...We've actually had this one asked before and have consulted with MaxxAir. Even though you can technically install the MaxxFan Deluxe Roof Vent #MA00-06401K wired to a separate switch, it is not recommended. The reason for this is that their fans…
view full answer...The Smittybilt XRC Gen2 bumper on the 2020 Jeep Wrangler has 3/4" thick d-rings so you can use the Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars part #RM-035 to tow with the D-rings on your bumper. Smittybilt is…
view full answer...It sounds you are looking for the Lippert 4 Point Control Panel W/ Amp Connector part #LC175225. The correct wiring harness to use with this control panel is the Replacement Lippert Components 4-Point Leveling System Control Brain Wiring Harness part…
view full answer...The Alpha Systems Superflex RV Roof Membranes like part #AL42CV uses a TPO membrane and the LaSalle Bristol RV Roof Membranes like part #3441700534142711435 uses a PVC membrane. The TPO membrane is more resistant to punctures and wear but the PVC…
view full answer...Sounds like the circuit board of your MaxxAir 8751K is shorted out and would need to be replaced with the part #MA10A04751KS. If that doesn't fix it the solution would be a new lift motor with the part #MA10-20270.
view full answer...I am happy to answer all of your questions about the Brake Buddy Classic 3 Supplemental Braking System part #HM39494. The Brake Buddy Classic 3 uses a built-in inertia sensor to detect when the motor home is braking then the the actuator arm will…
view full answer...Filter Your Search
Contact and Help