Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Garnish creates an attractive inside appearance for MaxxAir roof vents.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ellen: Hey, everyone. I'm Ellen here at etrailer.com. Today we're taking a quick look at the ceiling garnish. This is going to be for your MaxxAir MaxxFan RV roof vent. So, this is going to fit for several different roof thicknesses, since this measures about five and three quarter inches tall. See that there.
We'll be able to trim this down to match with our roof thickness so that we can clean up the look of our roof vent and make everything look nice and neat.This is also going to have the attachment point, so we'll have four mounting holes. You kind of see that there, to get that in place. It does not have any hardware that comes with it, so you will have to pick that up on your own. You'll need some flat top screws to install that, just four of those, and it looks at the diameter on those holes is about three sixteenths, so any hardware that will fit in there should work out well for you. As far as the width, outside edge to outside edge, it's about 13 and three eighths inches.
Same going this direction, or it's actually about 13 and five eighths inches, so it looks like this side just bows in a little bit. There's a little bit of a flex to it, so about 13 and a half inches either way, which is the pretty typical size. Most of your fans and vents out there are going to be 14 inches across, so 13 and a half inch rough opening or rough cutout will be about right.That's pretty much all there is to it for our ceiling garnish. Does fit several different MaxxAir MaxxFan roof vents. The complete list is on the product page here etrailer.com, if you want to check that out.
And if you need any other replacement parts or accessories to go with your trim ring, we do have a lot of other options here at etrailer.com, including sealant, fans and vents, and all kinds of other stuff. So, definitely check it out if you need it.Thanks for watching. See you next time.
It would be nice if these were an inch or so taller, but...these garnishes have a slight draft angle, so if you cut off the lip, they can be stacked to fill roof openings more than 6" deep (Jayco 5th Wheel).
This company has always come through with all my orders and quality products. The videos your company has have made product selection and installation very informative. Thank you.
Ordered this for my 2020 Jayco Pinnacle 32RLTS. Although, I am sure this part would fit just about any MaxxAir MaxxFan RV Roof Vent installation of this size. Before ordering, I confirmed the part number with MaxxAir. Then, ordered from etrailer. Love etrailer, they have great customer service, great prices and their site is filled with helpful information and videos for almost every part they stock. The original garnish in my Pinnacle was cracked around one of the screw holes, most likely due to over-tightening at the factory. The crack did not affect the function of the fan, just cosmetic. Installing the replacement from etrailer was fairly easy. Remove the old one by removing the four screws. The replacement needed trimmed around the top to match the roof profile which slopes in my application. Used the old garnish as a guide for size and trimmed the new with my oscillating saw. You could probably trim it with a utility knife or fine toothed hand saw as well. You will also need to drill new holes for the mounting screws. Again, use the old garnish as a guide. I also reused the screws from the original garnish. Screwed the new one in place and it looks great. One tip for working with white things and a white ceiling, wash your hands frequently to avoid leaving dirt and/or dirty fingerprints, etc.
Mike 
6/7/2024
A year later, it still looks great. We have the same fan in our bathroom and its garnish is cracked similarly to the one replaced a year ago. We have this on our list of fixes and to order from etrailer.
Perfect replacement for the Maxxair garnish ring. The original ring I cracked during the installation, and Over time that crack was getting larger, and was time to replace. I made sure I installed with a manual screw driver to avoid damaging. All worked out fine. The shipping took longer than I was used to, maybe because I chose the cheapest delivery option
Thomas
6/3/2024
Looks as if I just installed. No fading
Second replacement. Cracks where vent screws are attached.
Dg H.
10/31/2024
Replacement remains in good working condition No cracking. I made sure not to overtighten the screws.
Great replacement for lost trim ring. Would be nice for the 4 white screws to be an add-on option
Part was a perfect fit. After one year no issues.
Great priduct, works perfectly as an OEM replacement
Package delivered & in great shape. Thank you
Fit great cut easy
Got to me on time and just want I neede d.
I would have given 5 stars because I am surprised the plastic sleeves weren't wrapped in bubble wrap of some kind since they are pretty sensitive to damage but they turned out just fine.
Stewart
9/2/2024
Fan enclosures are great!!
Shipped in a really good protective box and no damage!
It was not a good fit for 2014 DRV with the Maxxfan. Not deep enough.
Fit perfectly and made the vents look
Brand new… be carry not to over tighten, they will crack
Great replacement ceiling garnish for my MaxxAir bath vent. The original one cracked. It was very easy to install.
Fits perfectly. Nice quality. Would be nice to have four white screws to come with it. Beside that love the product.
This product came promptly and in excellent condition. Unfortunately, we measured wrong and had to return it. The return process was simply and easy. I would recommend ordering items from etrailer!
Paul was great and made sure we got the right item we needed! Everything shipped really fast. Thank you for a great service.
Each trailer customer service was outst anding
Easy and great replacement for cracked garnish cover. Unscrew 4 screws, removed old garnish and rescrew new one in place. Easy.
It worked perfect,just what I needed!
Fit perfectly.
Very fast delivery, super happy!
Easy fast ordering, tracking and delive ry.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Gwendolyn Y.
2/26/2025
Hey Joe. I'm glad that our videos helped you and that you have always relied on us for your parts. We will do our best to always be there when you need us!