Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We do have motors that you can add to your landing gear. For example, the Landing Gear Set #RVLG-8000 can be operated with the manual crank #RVLG-HDL but you can also add the motor #LC142178 and switch #LG-145236 for effortless operation on your end.…
view full answer...We do carry some Lippert Hydraulic jacks but none by those part numbers. I tried looking them up on Lipperts site and found nothing on the 2571254 number and the 25712510 seems to have been superseded by a jack with a 14,000 lb. capacity, but not one…
view full answer...The Replacement Fan Motor Assembly Kit for Fan-Tastic Vent Roof Vent Fans #FVK8017-00 has the same hole spacing as the fan on your 6500 model so it will work. The diameter of the fan is a different than the original but it is the correct replacement.…
view full answer...You can go with a listed 29" model of the MORryde RV Cargo Sliding Tray as its actual width is 28-3/4". Please note the attached image showing dimensions of width. We have the #MR69FR that is 90" in length by 29" wide and has a 2…
view full answer...It sounds like you need to perform a zero point calibration since you replaced your Jack #LC99ED. Here are the steps you will need to perform. Level Zero Point Calibration To set the zero point (controller module must be fully secured in…
view full answer...Hey Troy, The Hydraulic Jack Assembly for Lippert Level Up System - 14,000lbs #LC99ED unfortunately is machined shut so the seals can't be replaced and would require a complete replacement of the jack leg.
view full answer...Hey Mark, thanks for all of the info you listed about your hub. With just that info we know that the hub/drum part #AKHD-655-35-EZ-K that you referenced is an exact replacement.
view full answer...To install the Replacement I-Beam Jack Bracket #LC349975 for Lippert Ground Control 3.0 #LC358590 you'll need to follow the instructions that came with the Lippert Ground Control 3.0. I've attached a cutout from the instructions for the…
view full answer...Yes, as a matter of fact we have just what you need. The Replacement Hydraulic Jack Assembly for Lippert Level Up System #LC99ED is the Lippert 236560 part you mentioned. This jack has a maximum weight capacity of 14,00lbs, and measures 21-7/8"…
view full answer...I am not sure of the exact model hub and drum assembly you have on your trailer, but the etrailer.com Trailer Hub and Drum #AKHD-865-8-K that we have for 8,000 pounds axles weighs around 68 pounds. Looking through the other similarly rated hub…
view full answer...While we do have what will work for you, both the wheel and tire need to have the capacity to handle that much weight and if you have 15 inch wheels, there are no tires that will fit which have the needed capacity. We also do not carry any wheels…
view full answer...For your 2005 Fleetwood Discovery the roof ladder I recommend the Surco Universal Exterior RV Ladder w Center Hinges for Contoured Rear Wall - 97" Long - 250 lbs #SP501L. The Surco RV Ladder Extension - Aluminum - 30-1/2" Long #SP504L or…
view full answer...Filters
1374 results
Vehicle Fit
Fit 2018 Ram 2500