Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The bearings and seals needed for the Titan Premier Disc Brake Kit #T2HRCM10DAC are sold separately. You'd need the #L68149, #L44649 and for a seal part #RG06-050 and you'd be set.
view full answer...Hey Kevin, thanks for the photos! According to the specs on your trailer your axles will fit with 3,500 lb brake parts so I recommend replacing your brake parts with the DeeMaxx Disc Brake Kit #DE66YR. This kit is perfect for boat trailers because…
view full answer...Hey Nicholas, thanks for reaching out! The rotors in the E-Coat Dexter Disc Brake Kit #K71-633-2 are being discontinued so even if we had everything else available separately in a different kit I'd recommend going with a different disc brake kit…
view full answer...The Dexter #42865-KIT will work with the Hydrastar #HSE7K-T1SO. These fit 8 on 6-1/2 bolt patterns on idler hubs designed for a 7,000 lb axle. Dexter is typically considered to be the highest quality which is why they usually cost more. The…
view full answer...According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…
view full answer...I spoke with my contact at Titan, and he said that the best way to remove the Replacement Filler Cap for Titan Model 10, 20 and Ultra-70 Actuators, #T4830600, is to use a six point 1-1/16 inch socket. He also said that if they have been on there a…
view full answer...Though we do have the replacement bearings, races, and seals available for your Hadco 3109 hub (which I have listed below), the combination used will not have an equivalent replacement hub available, unfortunately. Replacement Trailer Hub Bearing…
view full answer...Hey Mark, since we know your trailer has two 7k axles and a bolt pattern of 8 on 6-1/2 inch the correct DeeMax disc brake kit would be the part #DE66AR which comes with everything needed to add electric over hydraulic DeeMax brakes to your trailer.
view full answer...The phrase "the cold side of the brake switch" refers to the circuit at the brake switch that carries voltage only when the vehicle brakes are applied. This circuit varies widely from vehicle to vehicle so the best way we can recommend you…
view full answer...Hey Perry, thanks for reaching out. We certainly should have the parts you need for an oil bath conversion, but I will need to collect a bit more info on your axle in order to be sure you get the right parts. First I will need to know the weight…
view full answer...Hi Ed, In regards to the 3,500 lb Demco Hydraulic Brake Kit #40716-15 and the Hydraulic Trailer Brake Kit #AKUBRK-35-D, starting with the country of origin, the Demco are made in the U.S. and the opposing brakes (made by AxleTek) are made in China.…
view full answer...According to HydraStar, their #HSE7K-T1SO Disk Brake Kit with Actuator will take approximately 4-6 hours to install. This can vary according to how the trailer is equipped and how mechanically inclined the person completing the installation is. If…
view full answer...