Search: wire > Wiring >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…
view full answer...Hey Rogelio, thanks for reaching out. It is totally fine to use a no-drill bracket like part 18140 on a hitch with a square crosstube. People do it all the time and it works out fine. It's basically a hose clamp and once you tighten it, it can…
view full answer...Hello Gilbert, thanks for reaching out. We do have brakes and hubs for Dexter 4,400 lb axles, but the sizing for these 4.4K axles can be funky depending when they were made. The best way to confirm what you need is with the casting number on the…
view full answer...That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
view full answer...On each individual electric brake magnet the amperage draw would be 3.0 to 3.2 max amps at 12 to 13 volts on 7-inch brake magnets and 3.2 to 4.0 max amps at 12 to 13 volts on 10 and 12-inch brake magnets. The max amperage draw for the brake magnets…
view full answer...Hey Lee! The Victron parts can get pretty confusing. The Victron Orion-Tr #VN75ZR is only designed to be a power supply for DC loads, not for battery charging. You do not want to use this converter to charge any type of battery. To charge your…
view full answer...There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…
view full answer...You should be able to use the same size clip as the inner diameter of the wire loom. For example, the 3/8" Diameter Wire Loom #39035 has grooves in it that would allow you to use a 3/8" inner diameter clamp. Same thing goes for the…
view full answer...Hey Kevin, The part you're looking for is called the 'Torque Shaft', which unfortunately is not sold separately. I reached out to Lippert to see if they could just send one out and they stated if the torque shaft is needing replacement…
view full answer...Hey Jim! The Thinline LED Clearance and Side Marker Light - Submersible #AL91AB is an AL91 series light so you can choose from the following: -Mounting Bracket for Optronics A91, AL82, AL90, AL91, or AL191 Series Lights - Open Back - Black #A91BOB…
view full answer...First you will want to connect an 18 gauge wire to the Temp Sender mounted on your vehicle. You will then route the wire through the firewall into the passenger compartment where the Temperature Gauge is mounted and attach the Temp Sender wire to the…
view full answer...Hello Victor, thanks for reaching out. The Progressive Dynamics 9300 Series RV Converter Charger #PD79RR will work great for replacing your WFCO WF-9855 converter. We recommend this model as a replacement quite frequently in fact, since it has the…
view full answer...
Filters
