Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Kerri. The Replacement Fabric item #e96QV is going to be white when it's rolled up. This black fade fabric is designed to replace the ones on 15' wide awnings like our etrailer item #e24QV. What kind of awning do you have and what color…
view full answer...Hello Joe, Thank you for reaching out! The Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons #PM94FR does have the capacity you’d need, but since your fifth wheel’s frame sits about 25" off the ground,…
view full answer...You are going to need to replace your tail lights on your 2006 Karavan trailer with the LED Combination Trailer Tail Lights #STL57RB & #STL56RB. I was unable to find any information on your specific Wesbar tail lights as the information you…
view full answer...Hey Scott. You can send any pictures you have directly to the email address you receive this response from. We do not have any replacement parts for a TieDown Engineering LP7000 brake actuator but we do have a couple of replacement options. To…
view full answer...The pilot hole on a wheel is the big center hole right in the middle of the wheel. It fits over the hub.. It can be tough to measure these with the wheel still on the trailer so you will want to remove the wheel and then it will be easier to measure.…
view full answer...For your 2022 Volkswagen Taos, we do have the Vehicle Wiring Harness #C59236. This wiring kit with give a 4-flat connector and we power your trailer's stop, turn, tail, and running lights directly from the tow vehicle's battery.
view full answer...Hey Giff, I ran out to our warehouse and grabbed a set of the #VAL98MB to measure for you. I will attach a photo as well to better lay it out. The shorter section, or chock, is 7" long. The longer section, or ramp, is going to come in at…
view full answer...The 24x84 etrailer Cargo Carrier for RV Bumper part #e96ZR can hold a spare tire but there isn't any sort of specific mount for this. The photo attached below is a custom job from a neighbor and I'm not totally sure what they used to create…
view full answer...I'm guessing it is approximately 3-3/8" across if you measured it. Unfortunately there are no options that will slide in because it won't line up correctly, and everything is designed to fit a 3" tongue so it is too wide to mount an…
view full answer...Hi Cody! We get our fit/use info directly from manufacturers, and in the case of the Hollywood Racks Trail Rider Bike Rack #HR200Z, we have it listed for cars, trucks, vans, SUVs, and RVs (motorhomes). We don't have 5th wheels, travel trailers,…
view full answer...The Dexstar #AM20789 Mini-Mod wheel and the Americana #AM20906 valve stem are indeed compatible with each other, but the center cap you referenced, part #LHCS102-SI60C is compatible with a 3.19 inch wheel pilot hole diameter, and wouldn't work…
view full answer...The thickness of the tube is not any different as they are both 3 inch diameter, and the spindles are also the same utilizing the same inner diameter bearings, hubs, and seals. The difference in capacity is in the custom bend in the axle that creates…
view full answer...