What Is The Length Of The Ramp Portion On The Valterra Leveler And Chock?
Updated 11/20/2025 | Published 11/19/2025
Question:
What is the length of the “ramp” component? Not the chock, but the longer part… my acord are very close together, so anything over 12” is unlikely to fit between the tires.
asked by: Giff S
0
Expert Reply:
Hey Giff,
I ran out to our warehouse and grabbed a set of the # VAL98MB to measure for you. I will attach a photo as well to better lay it out. The shorter section, or chock, is 7" long. The longer section, or ramp, is going to come in at 12" long. Both are the same 5-3/4" wide.
What kind of application are you wanting to use these on?
expert reply by:
Nick S
0
Wheel chock diagram
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Valterra StayPut Curved Leveler and Chock - Single Axle
- Wheel Chocks
- Wheel Chock
- Trailer
- Plastic
- Textured Surface
- 1 Chock
- Red
- Valterra
more information >
Continue Researching
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Will the etrailer Anti-Rattle Hitch Collar Work w/ the Factory Hitch on a Subaru Ascent?
- Q&A: Will Storing Trailer on Grass/Dirt Damage Trailer Tires
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: What is the Weight Capacity for the Stackers StayPut Jack Pads and Leveling Blocks?
- Q&A: Hub & Drum With Electric Brakes Replacement For AL-KO 8700 Hub
- Q&A: Replacement Converter for WFCO WF-8955PEC for Lithium Batteries
- Q&A: Replacement Parts Available for Lippert Smart Jack
- Q&A: Is The Membrane Over A Lippert Smart Jack Control Panel Replaceable
- Article: Best RV Roof Vents
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Tire Sizing
- Article: How to Install a Roof Rack
- Article: Trailer Wiring Diagrams
Giff S.
11/20/2025
Thanks!