Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The inside channel of the H-Channel for Enclosed Trailer #36281-955 is approximately 1.027" wide so you would need to use 1" plywood or shim it to fill in the gap.
view full answer...Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…
view full answer...The C-Channel for Enclosed Trailer #362213-955 has an opening of 1.027". I have included an image below with all the dimensions for this item.
view full answer...I attached a chart that has all of the recommended lug nut torque specs for trailer wheels. Based on your studs being 1/2 inch, your wheels being 15 inches in diameter, and your lug nuts being coned you would want to torque your lug nuts to 90-120…
view full answer...While a lot of wheels have cross compatibility with 1/2"-20 or 9/16"-18 wheel bolts, the Karrier ST235/80R16 Radial Trailer Tire with 16" Aluminum Wheel #KE39JR states that it only works with the 1/2"-20 wheel studs. We do have…
view full answer...Did you have have the awning roller wound too tight when you initially installed it? At the time of installation the awning roller should be wound 12-16 rotations to put sufficient tension on the springs. Sounds like you may have yours wound too…
view full answer...Thanks for the great question. Not knowing how far either side has slipped I would remove all tension for the arm and start over at zero tension. To add tension to your Solera RV Slide-Out Awning - 6'7" Wide - 48" Projection - White…
view full answer...No, you will not need to remove the hitch to install the T-One Vehicle Wiring Harness with 7-Way Trailer Connector #118289. This is going to be a really simple, plug and play process so you've got nothing to worry about. You may want to consider…
view full answer...I spoke to TRC and they said the inside channel of the H-Channel for Enclosed Trailer part # 36281-955 is 1.027" wide.
view full answer...The H-Channel for Enclosed Trailer #36281-955 is specifically designed for use with building cabinets and doors on a trailer. It is a sturdy aluminum that will will work well with the door frame as it is rust proof and will not corrode like…
view full answer...The closest we have to match those measurements is going to be the H-Channel for Enclosed Trailer #36281-955 which has an internal width of 1.027" and a height of 2". We do also have a C-Channel #362213-955 which has an inside measurement…
view full answer...Although I would not be able to speak on the installation of the part(s) you received for your trailer, I can tell you that the TremPro 644 Silicone Sealant part #0160297 will do an excellent job of sealing your new aluminum panel to the trailer and…
view full answer...Filter Your Search
Contact and Help