Result: grommets

Ryan, absolutely - if you’re open to modifying the cutout or building fresh cabinetry, power centers like the PowerMax 45A #PM47VR, 55A #PM67VR, or 60A #PM77VR work very well in custom builds and remodels. In those cases, the exact replacement list…

Hey M, thanks for reaching out! Since you aren't seeing wires like what we show in the Redarc Tow-Pro Elite Brake Controller #RED44FR install video on a 2019 Ford Ranger, are you seeing a plug anywhere? The wiring is tucked up pretty far into the…

Hey Alfonso! The offset is 0 on the Kenda Karrier KR35 ST175/80R13 LRC Radial Trailer Tire w/ 13" Aluminum AM03 Wheel #KE22XJ. An offset of 0 is the standard for almost all trailer wheels. Are you looking for an offset or just confirming before…

The Dexter 008-480-05 is specifically designed to fit AL-KO axles. Unfortunately, the #8-407-5UC3-EZ will not fit AL-KO axles. Since these axles are no longer made replacement parts are not available. The best solution is to replace your 4,400 lb…

It looks like Trailer Hub and Drum Assembly - 5,200-lb Axles - 6 on 5-1/2 Item #8-201-5UC3 could be the right replacement for you. You can check the bearing numbers if you still have the bearings. If they are 25580 for the inner and LM67048 then this…

Hey Steven, The tube portion of the Replacement Rubber Grommet for RV Gray Water Tanks #F02-2105 is 2-1/4" and the lips stick out 3/8". If you cut the hole to 2-1/2" you've got a 1/4" gap from the inner tube portion to the…

If you are looking to replace your current OPT STL 82-RCB, we actually have this exact light available. The Optronics LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 10 Diodes - Oval - Clear Lens #STL82RCB will be the exact replacement you…

The light dimensions of the Optronics LED #TLL12RK are 7-9/16" long x 2-3/4" tall x 1-3/4" deep and the hole size needed is 6.75" by 2.5 inches. I confirmed this with my contact at the manufacturer and I've attached a template…

Yes, the difference is that the BUL72CBGK has the grommet included. To replace both the light and grommet you will need #BUL72CB and #A70GB. I looked at a few images of MasterCraft Trailers and while we don't have the exact information of what it…

Hey Rylan, I checked with Demco for you, and the Demco A-Frame Cast Head Coupler #DM37ZR will need Grade 5 hex bolts for installation. We don't have these but they can be found at any local hardware store.

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

You'd just have to physically go out to your trailer and measure the angle. So to do this, you'd need to get a protractor or something similar and place it on the edge of the inside on one side of the trailer frame, and check to see if the…