Result: GS2250DL

Hey Joe, thanks for the information! To replace your Dexter 072-079-01 leaf springs, I recommend the 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles item #EM28AJ. This is a 4,000 lbs leaf spring designed for 8,000 lbs axles. It's got 7-leafs…

Hi FR; for U-bolts you can use the Dexter U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles #APUBR-8. This will allow you to mount the 7-Leaf Double-Eye Spring #e89FV on your trailer. Keep in mind, increasing the leaf spring capacity…

The four bolt brake mounting flange for 8,000 lb trailer axles is going to be more or less an industry standard. This industry standard is 3-5/8" across left to right on center and 3-7/16" top to bottom on center. This could very well vary…

Hi Greg; leaf springs aren't typically used to raise a trailer. However, if the #EM28AJ matches your current leaf spring measurements, and your current leaf springs are 3-leaf, and the leaf springs are sitting on top of the axle, that would push…

Just the glass shade for the Gustafson RV Ceiling Light #277-000330-331 is listed as part #277-000331 on our site.

Hey Richard! I went out to the warehouse and measured the leaf stack on the 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles - 24-7/8" Long item #EM28AJ. It measures 2-1/2" tall. If you have any additional questions feel free to throw…

Hey Mark, I looked up the specs of the spring you have now and found that it is a 24-3/4 inch long spring from eye center to eye center and for a 7k axle. So that means that the replacement spring part #EM28AJ that you referenced will work great as a…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

We do have the correct bearing kit, along with the spindle washer and nut for your Lippert 5,200 lb axles. What you need are the following: - Bearing Kit #BK3-300 - Trailer Spindle Nut #165686 & Washer #SW1000

Hey Philippe, in my opinion the Hydrastar disc brake setups are the best because they have the best and most reliable electric over hydraulic actuator. We've found it's the most reliable and quickest reacting. So for a triple 7k axle setup…

Hey Jason! The Demco eZ-Latch Gooseneck Coupler #DM43KV can be locked via the pin hole behind the coupler (see attached photo) with the Trimax Coupler Lock #TMX38SR. Are you just wanting to make sure that your trailer stays connected to your truck?

Hey, Terry. Thanks for reaching out. AL-KO wasn’t always consistent with their axle components, so the best way to find the correct seal is by measuring. I know removing and measuring the existing seal isn’t always easy, but if you can get the outer…