Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…
view full answer...Hey Jarvis! For air bags to help support your camper and keep you level I recommend Firestone Ride-Rite Air Bags #F2609. These are the most durable and reliable option available. They have 5,000 lbs of load-leveling capacity, and you can run them at…
view full answer...If you plan to do some towing with your 2008 Ford Taurus X I would recommend going with a Class III hitch like the Draw-Tite Max-Frame #75299, which has been confirmed to fit your vehicle. Class III hitches have more capacity than Class II hitches…
view full answer...For the Bulldog trailer jack #BD195362 we have the replacement bevel gear kit part #BD500106, bearing kit #BD500251, and replacement handle #BD500105.
view full answer...Based on the dimensions you listed the equalizer you need is the part #TREQE1. This equalizer has 7-3/4 inches between the mounting holes from left to right and 2-7/8 inches vertically.
view full answer...Thanks for the picture Richard, I can tell by your picture you have a Model 6 surge actuator on your trailer which the #T4846500183 is the correct replacement for if you were wanting a channel style inner slide member replacement.
view full answer...I have a few different options for you, an air controlled trailer brake controller like the Hayes Air Actuated Trailer Brake Controller part #HA100400C or an electric controlled trailer brake controller like the Tekonsha Prodigy P3 Trailer Brake…
view full answer...The 50 degree a-frame trailer angle is the standard angle for a-frame trailers so it would be almost guaranteed that this Demco Coupler part #12660-97SP would fit perfectly. I don't have a way to open your picture but as long as the frame members…
view full answer...The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have include…
view full answer...The distance between the two tabs on the Roadmaster Direct-Connect Base Plate Kit #1437-3 is approximately 2-1/4".
view full answer...Roadmaster makes a base plate kit that is designed specifically for the Rugged Ridge bumper like you have which is part #1437-3 which you could attach a Roadmaster tow bar like the Falcon 2 #RM-520 directly to.
view full answer...Hello Tim, Happy to help you get the right light. The information that I found on the DOT 16P2ST2 T35 16, it appears to be a 6-inch oval LED combination light serving as a stop, tail, turn, and reverse signal. For a replacement you can use the TecNiq…
view full answer...