Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The most popular trailer wheel bolt pattern is the 5 on 4-1/2 inch bolt pattern and as far as we are aware the bolt pattern you mentioned is not used on trailers at all. So my bet is you probably have the 5 on 4-1/2 inch. I attached a help article…
view full answer...Hey Keith, The right wiring harness for your 2024 Pilot is the #C48ZV. This is a simple plug and play installation that would get you that 4 flat connection in the rear. I attached a installation video of this on a 2024 Pilot for you. Since your…
view full answer...When you are hardwiring a trailer brake controller like the Prodigy P2 #90885 the red wire connection that provides the triggering signal to the controller should be made to the wire on the COLD SIDE of the brake light switch circuit. This is the…
view full answer...Normally you can find the brake light switch under the dashboard at the top of the brake pedal. There could be a number of wires attached to the switch so you can use a tester like part #PTW2993 to test the wires. Since the auto manufacturers can use…
view full answer...The EcoHitch #EH34FR doesn't provide an integral bracket for installing a 7-way trailer connector. We offer bracket mounts that usually work pretty well, which will use a pipe clamp to attach to the hitch crossbar, but because the crossbar will…
view full answer...With just the one connector you referenced, the Curt T-Connector Vehicle Wiring Harness with 7-Way Trailer Connector #C56278 or the #C56306 will work well. I've attached a video that shows this installation with just the single connector to…
view full answer...To add a 7 Way wiring harness to the Draw-Tite #76253, you will need the Draw-Tite Mounting Bracket #18138. This will attach to the included no drill bracket already on the hitch, making it an easy install. However, this bracket does not work with…
view full answer...There are often two different harnesses at the back of the 2015 Ford Explorer and it looks like you just have the incorrect one; occasionally they're in slightly different spots but there will only be 1 plug to install trailer wiring on a 2015…
view full answer...There is very little difference between the Curt #C56278 and the #C56306. Even the instruction manuals that they come with are identical. The only difference I noted is that the #C56278 is listed for 2011-2015 Ford Explorer, and the #C56306 is listed…
view full answer...If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…
view full answer...The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…
view full answer...Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
view full answer...