Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The main reasons why trailer tires blow out is heat generated from under inflated tires and overloading the tires. Trailer tires should be inflated to the maximum psi indicated on the tire. A tire in the same size but with a higher ply rating would…
view full answer...You are correct that the replacement motor for your Power Gear 523900 is the 1010000010 you referenced, and we do carry this part. It is listed on our site under a different part number, but is the exact same thing, the Replacement PowerGear RV…
view full answer...The Atwood GE16EXT 10 gallon water heater has 23.5" x 19.4" x 18.2" dimensions so you'll have to make alterations to the cutout hole to fill in the gap from any of the water heaters we carry. I recommend the Furrion RV Tankless…
view full answer...The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…
view full answer...The correct replacement grease seals for your #22333TC seals is part #RG06-070. This includes two double lip seals and they have the same inner diameter, outer diameter and thickness as your current seals. To replace your brake assemblies on your…
view full answer...I reached out to AirLift to see what could be going wrong with your Air Lift WirelessAIR Compressor System part #AL74000. They informed me that the A-09 code is a low voltage code. With this issue you want to check all of the connections on the…
view full answer...The factory prep package or pucks are not the same between Ram, GM and Ford. The spacing is all different which means you cannot use a 5th wheel hitch for Ram pucks on a GM with pucks. Take the Curt A25 5th Wheel Trailer Hitch for example which is…
view full answer...I spoke to my contact at Lippert about the issue you are having with your Lippert Ground Control Leveling System. They informed me that there is a problem with the valve on the front leg. The valve is either being bypassed or the set screw on the…
view full answer...According to the good folks at Demco, you can expect to have as much as 3/4 of an inch of vertical play in a 2-5/16 inch coupler like the Demco #DM15633-81 without having an issue. This is necessary, otherwise you could have problems when trying to…
view full answer...After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…
view full answer...I reviewed quite a few photos of various Charmac cargo trailers and while I found some with external fenders I did not find any shown with lights installed. However, we do offer a lot of combination red/amber trailer lights and all are shown on the…
view full answer...We've had customers use the CE Smith Post-Style Guide-Ons for Pontoon Boat Trailers #CE27670 on tri toon boats like yours that have the extra fins like yours have and they worked great. I attached a picture of this for you to check out as well. I…
view full answer...Filter Your Search
Contact and Help