Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Since the aftermarket trailer brake controller says N.C (Not connected) when the pin is installed in your breakaway switch, but .c (connected) when the pin is removed it is more than likely due to the breakaway kit wires are connected incorrectly…
view full answer...I attached a picture of a 4-bolt mounting flange like what the brake assembly part #AKEBRK-2 you referenced is designed to attach to. This is a standard dimension so I would be shocked if the flange on yours was different.
view full answer...I can help you determine which wire at the brake switch on your brake pedal carries the Stop Light Switch circuit, but we do not have any vehicle specific information about the color of the stop light switch on your 2013 Toyota Sienna. To determine…
view full answer...As long as your Toyota Sienna hitch is rated for weight distribution like the etrailer part #e98837 is and it has a set of higher weight capacities when used with a WD system what you are wanting to do is possible. This particular hitch has a 5,000…
view full answer...In order to choose the correct replacement axle for a trailer you'll first want to start with the weight capacity. The weight capacity can be found on the axle tag in the center of the beam. Then, you'll need to measure the…
view full answer...Yes, the Trailer Hub part #AKHD-545-2-2K that you referenced is compatible with the brake assemblies #AKEBRK-2L and #AKEBRK-2R. The bolt pattern is the standard brake mounting 4 bolt pattern of 4 on 4 inch.
view full answer...For your 2 jetski trailer, the least expensive way to add brakes is an electric brake. To do this, I recommend adding the Electric Trailer Brake Kit - 7" - Left and Right Hand Assemblies - 2,000 lbs #AKEBRK-2. This will mount to your…
view full answer...Hub and drum assembly #8-276-5 is not a proper fit for 7 x 1-1/4 inch brake assemblies and should not be used with them. I know you are looking to save some money but believe me, you can spend a little now on the correct hub and drum assembly,…
view full answer...Already having the flanges on your axle will make things a bit easier, but you will need to verify a few things to make sure everything will be correct. The Electric Trailer Brake Kit - 7" - Left and Right Hand Assemblies - 2,000 lbs…
view full answer...There are many things that can affect the voltage on the brake output wire from your brake controller to your trailer brakes such as the power setting on your brake controller, how you are testing the wire and if you are testing it with the brakes…
view full answer...Yes, the Demco Channel Tongue Trailer Coupler #12564 that you referenced does accept a 2-inch hitch ball and mounts to a 3-inch-wide trailer tongue. It's mounting hole spacing is indeed 3-inches and it offers a 10,000-lb weight…
view full answer...The hole diameters for the Demco Channel Tongue Trailer Coupler item #12564 are 1/2 inch. It is recommended to use grade 8 hardware to attach the coupler to your trailer frame. You can find these bolts at a local hardware store as they do not come…
view full answer...Filter Your Search
Contact and Help