Differences Between Curt # 13323 and Draw-Tite # 75236 Class III Hitches for 2009 Toyota Tacoma

Updated 10/01/2014 | Published 09/30/2014

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(376)

$161.44

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(742)

$51.94

1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs

(2617)

$11.37

2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs

(1356)

$12.58

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(366)

$168.54

Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs

(3828)

$28.08

etrailer Trailer Hitch Receiver Lock for 2" Hitch - Flush - 2-5/8" Span - Stainless Steel

(1303)

$35.25

Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span

(894)

$16.51

Question:

Im looking at getting a hitch for my Tacoma. Is one the following hitches better suited for my vehicle or does it matter? CURT 13323, DrawTite 75236 I have a 2009 Toyota Tacoma Double Cab 4 Wheel Drive Thanks

asked by: Patrick

Expert Reply:

The Curt # 13323 and the Draw-Tite # 75236 Class III hitches share the same weight capacity and installation procedure. The appearance and design of the two hitches are pretty similar. As far as quality goes, both brands are about equal. Given this, there's no reason why you couldn't go with the less expensive Curt model.

If you were planning on towing with your Tacoma, you might also need the following:

Trailer wiring harness, part # 118496
Ball mount, part # D-4
Hitch Pin and Clip, # PC3
1-7/8 inch trailer ball, part # 19260
2 inch trailer ball, part # 63845
Locking hitch pin, part # e98882

I've linked you to some installation videos, which I hope you'll find helpful.