Height of Springs Used By Timbren # TDVR05096 Suspension Enhancement for 2005 Dodge Grand Caravan

Question

Question:

Im looking at the Timbren Rear Suspension Enhancement System for my 2005 Grand Caravan - Code: TDVR05096. Can you give me the dimensions of the rubber springs - how tall are they? Thank you.

asked by: Jay S

0

Expert Reply:

According to my contact at Timbren, each spring unit is 5 inches tall. The spring itself is 4-3/4 inches tall, and the mounting plate is 1/4 inch thick. The Timbren spring will replace the factory bump stop.

expert reply by: Mike L

0

click to enlarge

Answer 1

Although not always necessary, it is always a good idea to upgrade the vehicle for towing a heavy load for an extending period of time. In order to tow a 16' camper that weighs roughly 2,500 lbs. when dry, with a 2005 Dodge Grand Caravan, I…

view full answer...

Answer 2

The Timbren Rear Suspension Enhancement System part #TDVR05096 which is a fit for a 2007 Dodge Grand Caravan installs with a weld nut inside the frame. I have attached a screen shot of the instructions which explains this below.

view full answer...

Answer 3

I did some checking and your 2007 Dodge Grand Caravan has a towing capacity of 3,700 lbs so you'd be within capacity to tow a 3,200 lb trailer. For a hitch you'd want the part #75305 for if you have the stow n go rear seats or part #75119 for…

view full answer...

Answer 4

The Timbren Rear Suspension Enhancement System #TDVR05096 could be just what you need for your 2010 Sedona. These are designed to help reduce road shock and increase stability when the vehicle is carrying heavier loads. They are not designed to…

view full answer...

Answer 5

I have a solution for you, but the replacement parts you're looking for on your K650 winch are not available. However, the Fulton High-Performance Brake Winch - Winch Only - 1,500 lbs #F143100 is also a K series winch and will have a similar (but…

view full answer...

Answer 6

The lens you are looking for is the part #30-86-712 which is the correct amber lens for the 86 Series Bargman taillight #30-86-203 thats in your picture.

view full answer...

Answer 7

In order to install the Timbren rear suspension enhancement system #TDVR05096, the first thing you will need to do is lower the rear control arm. In order to lower the rear control arm to remove the coil spring, remove the inner control arm bolt by…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...