How To Re-Pair an Even Brake to a Transmitter After Screen Just Reads Even Brake
Published 08/01/2014
Question:
Our system stopped working between trips. Everything is getting power. The monitor has a green light in the upper rt. hand corner and the display reads Even Brake. When I pushed the ion arrows every section was blank except the serial number. Im thinking maybe we need to re-sync the receiver with the sender. If so how do u do that?
asked by: Marj
Expert Reply:
According to Roadmaster this means that the monitor is not programmed to the ICX transmitter. The ICX transmitter and the motorhome monitor are programmed as a set but you need to reprogram yours to match apparently.
Press the Dim button on the motorhome monitor after plugging it in for about 6 seconds until the LCD reads, "receiver in learn mode."
Release the Dim button and it should read "Learning ICX #1 --Advance OK."
Press the Test button on the Even Brake Touch pad control panel. It should begin a self-diagnostic test. Once complete the test light will illuminate green indicating it is paired and ready to go.
If it is red then there is a problem and you should check the motorhome monitor for detailed information.
Product Page this Question was Asked From
Roadmaster Even Brake Portable Flat Tow Brake System - Proportional
- Flat Tow Brake System
- Brake Systems
- Proportional System
- Every-Trip Setup
- 12V Outlet
- Portable System
- Not Power Assist Brake Compatible
- Air Brakes
- Air Over Hydraulic Brakes
- Hydraulic Brakes
- Wireless Display
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Shop: Dexter Zinc-Plated Brake Actuator - Disc - Multi-Fit Ball - Bolt On - 7,000 lbs
- Shop: Dexter Zinc-Plated Brake Actuator - Drum - Multi-Fit Ball - Bolt On - 7,000 lbs
- Search Results: curt 58964
- Shop: Vehicle Tow Bar Brake System
- Shop: Vehicle Tow Bar Wiring
- Shop: Base Plate for Tow Bar
- Shop: Roadmaster Stop Light Switch Kit
- Shop: Curt Custom Tail Light Wiring Kit for Towed Vehicles
- Shop: Curt Custom Base Plate Kit - Removable Arms
- Shop: Replacement Rubber Sleeves for Curt Rambler Tow Bar - Qty 2
- Search Results: hitch spacer
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: dle60cp
- Search Results: rv water heater
- Q&A: Tankless Water Heater To Replace A Truma AquaGo With Telephone Style Communication Cable
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Search Results: trailer hitch
- Search Results: trailer wiring
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Suspension Enhancement
- Search Results: trailer tires and wheels
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Measure for Trailer Hitch Drop
- Video: Curt Powered Tail Light Converter Installation - 2023 Kia Telluride
on Flat Tow Brake System
