Need Orifice Fitting to Connect Brake Line to Demco Plastic Master Cylinder

Updated 07/30/2014 | Published 07/27/2014

Products Featured in This Question

Replacement Brass Connector for Dexter Disc Brake Actuators - Qty 1

(15)

$8.47

Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2

(2738)

$6.23

Question:

i need the oriface fitting for the brake line to hook to the demco plastic master cylinder. drum brakes. 4. two axles.. and the right wheel seals. 3500# dexter axles. 4. i will send back the wrong ones.

asked by: Lynn

Expert Reply:

After speaking with my contact at Demco, you will need a 1/8 to 3/16 inch orifice fitting like Brass Connector, # T4750300, to connect the brake line to the master cyclinder.

The hubs that typically come with a 3500 pound Dexter axle require the use of Grease Seal 10-19, # . These seals come two in a package and have an inner diameter of 1.719 inches and an outer diameter of 2.565 inches. Using a digital caliper, you can measure the inner diameter of your hub and the outer diameter of your spindle where the grease seal sits to verify that these are the correct seals for your axle .

expert reply by: Leah S