What is the Capacity of the Trailer Valet Jack and Trailer Mover

Question

Question:

I have a 27 ft boat. After reading the comments I kind of worried. What is the limit on this product?

asked by: Kathleen L

0

Expert Reply:

The Trailer Valet, # STC-V211, is rated for 500 pounds tongue weight. Typically boat trailer tongue weights are lower than regular trailer tongue weights because boats are heavier at the back. The unit has a 5,000 pound gross trailer weight capacity.

expert reply by: Michael H

0

Answer 1

Trailer Valet actually has a dolly/jack that is designed for attaching to the coupler like you mentioned. For that you'd want the part #TVXL25 for if you have a 2-5/16 inch hitch ball or part #TVXL2 for if you have a 2 inch hitch ball size. I…

view full answer...

Answer 2

The Trailer Valet 5X Swivel Jack and Trailer Mover #STC-V211 does not always have to be attached to the trailer. The mount is able to stay on the frame and you can store the mover in your trailer, vehicle or leave at home. I personally prefer to…

view full answer...

Answer 3

For a trailer dolly that will work with your boat and trailer, I would recommend looking at the Trailer Valet XL Trailer Dolly, #TVXL2. This trailer dolly has a tongue weight capacity of 1000 lbs which is the highest tongue weight capacity of our…

view full answer...

Answer 4

Technically if your trailer has a tongue weight (TW) of 500 lbs then it falls into the 500 lb max TW rating of the Trailer Valet 5X Swivel Jack and Trailer Mover #STC-V211. The only problem that I see is that you are at the max capacity of this jack…

view full answer...

Answer 5

Hello Peter, Thanks for writing in! Since your Ranger boat trailer is equipped with a Dexter XR84 brake actuator, the Replacement Solenoid Valve #T4748800 is the correct replacement. It is designed for Dexter brake actuators with an electric reverse…

view full answer...

Answer 6

What I recommend is to wire up the lights via a switch installed inside the trailer and connected to the battery. You can mount the battery where needed but 10-gauge wire will be too large for lights. A lot depends on the lights and how much power…

view full answer...

Answer 7

There is no weight rating for the Mounting Bracket, part #TV-0002. It is designed to replace the bracket for the Trailer Valet Trailer Jack, part #STC-V211. The Trailer valet has a weight capacity of 500 lbs. You may be able to install a different…

view full answer...

Answer 8

Hey Ted, thanks for reaching out. The Trailer Valet 5X Swivel Jack and Trailer Mover #STC-V211 does ok on evenly compacted gravel. The problem is rough macadam or stone can be less compacted and more uneven so you probably wouldn't have great…

view full answer...

Answer 9

That's a really good question, Dan! For this type of set up you would need to attach the Parkit360 Transformer, part #PA66VR, stabilizer bars to the kingpin box instead. I've gone ahead and included attachments that show step by step how to…

view full answer...

What is the Capacity of the Trailer Valet Jack and Trailer Mover

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching