How Does InterVac Rear Hose Connect to Vaccum Base
Published 08/06/2026
Question:
@JamesonC From what I see in this diagram, this does NOT show the back of the CS8. Rather it is showing the Vacuum Valve to be able to have a remove hose and the hole that is to be cut is for that valve, not the back of the CS8. Am I wrong? I still don't see how a hose from the VacPort to the somewhere on the back area of the CS8.
asked by: Phil
Expert Reply:
Hey Phil, after we talked last I realized I walked by one of the Intervacs # IV88FR we have on a nearby desk that was getting used for a training the other week and I saw it has the rear port. I took some pictures that I attached below that shows how it goes. You will need the flanged intake fitting # IV98VR as well to connect the part # IV98FR.
Product Page this Question was Asked From
InterVac CS8 Vacuum Cleaner - 120 Volt
- RV Vacuum
- RV Interior
- Central Vacuum System
- 110 - 120V
- Manual On/Off
- Power Unit
- InterVac
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will The Firestone Ride-Rite Air Bag And Compressor Kit F24XV Fit A 2025 Ram 2500 With Factory Pucks
- Q&A: How Does InterVac VacPort Connect to InterVac CS8 Vacuum Cleaner
- Q&A: Recommended Hitch for a 2025 Toyota Corolla LE
- Q&A: Best Rear Suspension Enhancement For 2020 Ram 2500 4WD With In-Bed Gooseneck Hitch
- Q&A: Can MORryde I-Beam Stabilizer Install on Camper with Underbelly Cover
- Q&A: Best Way To Lift a Forest River Grey Wolf 26DBH
- Q&A: Is LaSalle Bristol Part # 34466N4AB96GMA Same as 66N4AB96GM
- Article: Cleaning Your RV Gray Water Tank in 5 Easy Steps
- Article: Trailer Tire Sizing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Hitch Mounted Cargo Carrier Information
- Article: What Is Flat Towing and How to Ditch the Trailer