Replacement Clearance or Side Marker Light for a 20321-02 Light

Question

Question:

We have a side marker that is missing the lens only. Nothing is broken just missing the red covered lens. The light part number is 20321-02, could you help us locate the right one please. Thank you so much for your assistance on this matter.

asked by: Cheryl D

0

Expert Reply:

Hey Cheryl. I have a solution for you but your 20321-02 light has been discontinued and there's no replacement lens available for it. I recommend replacing your light with the Trailer Clearance or Side Marker Light w/ Reflector item # MC44RB.

The Trailer Clearance or Side Marker Light item # MC44RB has a red lens and measures 4" wide x 1-1/2" tall x 15/16" thick. It has mounting holes spaced 3" apart on center and uses a simple 2-wire power and ground installation method.

What kind of trailer do you have?

You can add this information, along with any other questions you have, where it says Add Comment.

expert reply by: Jerred H

0

MC44RB
(click to enlarge)

Handyman

7/12/2026

very EZ to replace the whole light. 2 Screws and two wires very EZ to do.

Jerred H.

7/13/2026

@Handyman That's great to hear! Thanks for taking the time to share that feedback!

Answer 1

The best way to power a 12V refrigerator while in transit would be with an on-board battery. The battery charge line circuit which is the one ran through the trailer connector you're referring to likely won't be able to provide enough power.…

view full answer...

Answer 2

The closest LED replacement we have for the Trailer Clearance Light part 154A-R is the Thin Line LED Fender Clearance Light part #MCL65ARB. This light has both a red/amber lens, 10 diodes, and measures 3-15/16" long x 1-1/4" wide x…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Replacement Clearance or Side Marker Light for a 20321-02 Light

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching