bing tracking image
Q & A Icon

Where Does the Washer Go on the SumoSprings Helper Springs SS65FR on a 2024 Chevy Silverado 1500?  

Updated 06/21/2026 | Published 06/18/2026

Products Featured in This Question



Question:

On SumoSpring 24 Chevy Silverado 1500 4x4 with 2-1/2inch lift is it necessary to use the steel 4inch mounting plate when using 2 one-inch spacers? If so, where do I install the plate? And do I use a nut as the bolt passes through the center of the spring body and tighten it into a nut hidden inside or atop of the spacer seems to have a perfect cut out to place a nut to make it a rigid assembled unit before i bolt the entire piece to the frame of the truck.

0

Expert Reply:

Hey Dave, welcome back. The 4" diameter washer will need to be installed between the blue SumoSpring and the 1" spacer on the SumoSprings Solo Custom Helper Springs item # SS65FR. The bolt that attaches the SumoSprings and spacers to your Silverado's bump stop bracket, will pass through the helper spring with the head of the bolt at the bottom and the threaded side sticking out above the spacers.

The SumoSprings Helper Springs item # SS65FR with the spacers installed needs one complete bolt to attach to your Silverado. You won't need to make a cut in the spacer and connecting it to your Silverado's bump stop perch makes it one complete unit that's solid and reliable.

I linked the installation instructions below for the SumoSprings item # SS65FR. I also attached a picture below so you can see the metal washer installed beneath the spacer.

When the SumoSprings Helper Springs item # SS65FR are installed on your Silverado 1500 you will want to have a 1/2" - 1" of clearance with no additional cargo weight in the bed. This allows for you to have a comfortable ride when you are not towing or loading down the bed of your truck.

Do you tow a trailer or haul heavy loads in the bed? What has you adding SumoSprings to your Silverado?

You can add this information, along with any other questions you have, where it says Add Comment.

expert reply by:
0
Jerred H
SS65FR
SS65FR
(click to enlarge)
Eric profile picture

Eric

6/21/2026

I installed the SumoSprings Solo Custom Helper Springs item # SS65FR on my 2021 1500 Silverado LT with the spacer first but later removed the spacers since I don't have any lift on my truck and they were touching full time. That caused my unloaded ride to suffer greatly. I got them since I pull a 6000 pound RV and they helped the rear end sag tremendously. I say you can just try the in to start and see how they effect the daily drive ride. Good luck

Bd profile picture

Bd

6/21/2026

I have a 2025 ZR2 1/2 ton, it has a factory 2" lift. I run 1" spacer when empty and it doesn't affect ride at all. Added another 1" spacer when towing my Jeep on trailer. It definitely helped Gross trailer and truck weight was 13k , used a WDH and ride was good and pretty close to level.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>