Troubleshooting Lights Not Working On 2023 Flagstaff Classic Camper
Updated 05/09/2026 | Published 05/05/2026 >
Question:
I have a 2023 Flagstaff classic camper and my running lights work on the camper but don’t have any signal and brake lights at all. I’ve checked my fuses and connections on the truck and trailer and they are good and even hooked a whole different truck up to it and same problem. What else could I do?
asked by: Ray
Expert Reply:
Hey Ray! Since you tried out a different vehicle and had the same issue we can rule out the vehicle side. The first thing I would do is check your ground connection and make sure it is secure.
After that, I would go ahead and hook it up, run your brakes or signals, and test for power on the trailer side. Start by testing right behind the trailer connector. If you don't have power here then the connector is likely the issue and you can replace it with # PK12706. Otherwise, work your way back and check for a short in the wiring, repair as necessary.
Product Page this Question was Asked From
Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Search Results: epdm rv roof repair
- Shop: Alpha Systems 4034 Roof Coating for RV Roofs - 1 Gallon
- Video: Alpha Systems 8011 Adhesive for RV Roofs Spec Review
- Video: Alpha Systems 4034 Roof Coating for RV Roofs Feature Review
- Shop: Alpha Systems 8011 Adhesive for RV Roofs - White - 1 Gallon
- Shop: SoftStartRV Soft Start for Single Zone Air Conditioner Setup - Qty 1
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: trailer hitch
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Trailer Hitch
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Video: Hands-On with the Hub Saver Hub and Wheel Protector
- Search Results: trailer wiring
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Shop: Suspension Enhancement
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Shop: Brake Controller
- Search Results: trailer jack
- Video: Review of etrailer Trailer Hubs and Drums - Hub with Drum - AKHD-545-35-EZ-K
- Q&A: What is the Best Grease for Trailer Bearings
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer lights




Dan
5/9/2026
I second Ray's input. Many times with lights it's a ground. I had an issue however that was a severed wire on the Lt rear turn signal. Tearing into a little Jayco was not fun.. but there it was a severed wire still in the insulating jacket. Check for a brake signal on your vehicle harness first... then onto that trailer harness staring up front. You'll get it. Best, dan