Scissor jacks vs Ultra-Fab Power Twin II Electric Stabilizer

Question

Question:

Which is better electric scissor jacks or electric Ultra-Fab Power Twin II Electric Stabilizer?

asked by: Dan

0

Expert Reply:

The only scissor jacks we carry are manual adjusting. The Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors # UF39-941705 that you referenced would be an excellent choice for stabilizer jacks on your camper or RV as long as your frame width is between 48 and 80 inches in width.

This would be a way more convenient option than manual scissor jacks for stabilizing.

expert reply by: Jameson C

0

Answer 1

Technically, as long as you have the space you could add as many stabilizers as you like to your trailer. The Lippert stabilizers you currently have are great for stabilization, but can't be used for leveling so the Ultra-Fab Power Twin II…

view full answer...

Answer 2

The correct replacement motor is part #LG-142178, and the Replacement Aluminum Gearbox, #LG-179015. The correct replacement switch is the part #LG-145236.

view full answer...

Answer 3

Hey Joe! Internal sensors typically last longer, are shielded from the elements, and will get a slightly more accurate reading. They also provide protection against theft if that is a concern. The down side is you have to remove the tire to mount…

view full answer...

Answer 4

Hey Mike, congrats on the new trailer. The Tire Linc Pro TPMS for RVs and Trailers item #LC77VC is the Lippert TPMS Prep. This is just the aftermarket version of what gets installed on newer trailers. It includes four sensors that mount to a trailer…

view full answer...

Answer 5

Thanks for the information David and welcome back! The Hellwig Rear Anti-Sway Bar item #HE78RR is the correct one for a 2026 Ford E-450 chassis. However, for the front you'll need the Hellwig item #HE26GR. This is a 1-3/8" diameter front…

view full answer...

Answer 6

I contact Ultra-fab and since the socket on the Ultra-Fab Power Twin II Manual Stabilizer for Trailers and RVs part #UF39-941704 is not a standard hex socket head there is not a way to raise and lower the stabilizer with a power drill. The socket on…

view full answer...

Answer 7

Hey David! For your Grand Design Reflection 295RL I recommend the Ultra-Fab Power Twin II Manual Stabilizer #UF39-941704. This will provide support across the width of your 5th wheel to remove any unwanted movement. It has a bolt-on installation and…

view full answer...

Answer 8

Welcome back Rich and thanks for the information! To replace your Sharp Carousel microwave R-820BK-F, I recommend the Greystone Built-In RV Convection Microwave item #GR27FR. It measures 21" wide x 11" tall x 15-3/4" deep.…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Scissor jacks vs Ultra-Fab Power Twin II Electric Stabilizer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching