Looking for Replacement Bugscreen for Maxxair RV Roof Vent Cover

Question

Question:

Hi…. I am looking for bug screens for the original maxxair vent cover and the maxxair 2, both in translucent white. I do not have the model numbers but both were purchased in 2021. Thank you

asked by: Doug M

0

RV Roof
(click to enlarge)

Expert Reply:

Hey Doug, we have replacement bug screens for the Maxxair roof vent covers with the part # MA00-955203 for the FanMate style and the part # MA10-20121 for the MaxxAir II which it looks like what you have on the right side of your picture. We don't have a screen for what's on the left if that is also a Maxxair.

expert reply by: Jameson C

0

Answer 1

The bumpers on an RV/motorhome are normally not rated to tow anything or carry anything remotely heavy. Instead what you need is a new trailer hitch receiver added on to your trailer. I recommend the Curt Adjustable Trailer Hitch Receiver -…

view full answer...

Answer 2

Hey David, we have the replacement screen for the Maxxair II vent with the part #MA10-20121 that you referenced but we do not have the frame as well. If the frame is damaged as well you'd need to replace the entire lid cover with the part…

view full answer...

Answer 3

Yes, the correct replacement bug screen for your MaxxAir II RV and Trailer Roof Vent Cover part #MA76JR is the Replacement Bug Screen for MaxxAir II RV and Trailer Roof Vent Covers part #MA10-20121.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 10

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Looking for Replacement Bugscreen for Maxxair RV Roof Vent Cover

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching