Availability of Custom Wiring Harness for Redarc Tow-Pro Elite Installation on 2023 Subaru Ascent

Question

Question:

I have a 2023 Subaru Ascent Limited with the dealer installed towing package. I am interested in purchasing a Redarc RED44FR brake controller and want to ensure it will be easy to install on my vehicle, and if I need to purchase any adapters for easier installation. Thank you.

asked by: Andy B

0

Expert Reply:

Hey Andy! Since you have the tow package on your 2023 Subaru Ascent there is a custom wiring harness available. You will still need the Redarc Tow-Pro Elite Brake Controller # RED44FR. Then you can use the Curt Custom Wiring # C48RJ along with the Redarc Curt Adapter # 331-TPH-019. This will allow you to plug directly into the OEM brake controller port on your Ascent.

If you want to save a little money, the same two wiring harnesses will also work with the Redarc Tow-Pro Liberty # RED24FR. This lacks the "off-road mode" but for most people that isn't necessary.

What will you be towing once the brake controller is installed?

expert reply by: Robin H

0

Tow-Pro Control Knob
(click to enlarge)

Andy B.

3/12/2026

This is perfect, thanks. I do plan on towing off road from time to time, which is why I wanted to go with the the tow pro elite. Thanks so much.

Robin H.

3/12/2026

@AndyB sure thing, I understand. I like to give people the option since sometimes they look at the Elite # RED44FR and think the most expensive must be the best. No reason to spend the extra if you won't use all of the features. They're both awesome, definitely my favorite brake controllers, be safe out there and let me know if you need anything else!

Scott

3/13/2026

@AndyB I have 3 RedArcs in my Tundra,Expedition, and Explorer. You won't be disappointed they are intuitive, adaptive, and responsive. Let alone don't knock my knees anymore with old school style controllers. At least with the Toyota install you can also use the factory "blanks" on the dash to use the RedArc replacement blank for a clean install.

David S.

3/13/2026

I purchased this controller a year+ ago and it has worked flawlessly for me. I do not go off-road, but I do travel coast to coast and this unit is easy to operate and works well with my 5000 lb. Single axle trailer and my 9500 pound dual axle trailer. I would purchase again if I get another vehicle. One of the caveats for me, I had the dealership install it in my truck when new and was told that unit is covered by my vehicle warranty because the dealership did install it.

Jon K.

3/13/2026

This unit is Sooo much better then the under dash models I had in the past. It works flawlessly.

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 12

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Availability of Custom Wiring Harness for Redarc Tow-Pro Elite Installation on 2023 Subaru Ascent

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching