Can Progressive Dynamics 9300 Series RV Converter Charger Be Mounted Vertically
Updated 03/07/2026 | Published 02/28/2026
Question:
Can this be mounted vertical?
asked by: Rod
Expert Reply:
Hey Rod! Yes, the Progressive Dynamics 9300 Series RV Converter Charger # PD69RR can be mounted vertically. Horizontal mounting is preferred but it can be mounted in any position as long as it has proper ventilation and you aren't blocking the fan and vent holes.
What rig are you adding the converter charger to?
(click to enlarge)
Austin
3/5/2026
easy install, works well on lithium batteries, does make a hum noise when charging. A separate fan would be quieter.
Mike
3/5/2026
It is a great product; I installed it to charge lithium batteries. The charger can be mounted in any position as long as you leave room for air to circulate around it for cooling. I have used progressive dynamics products for over 25 years and ad they always worked well.
Dan
3/7/2026
I mounted mine vertically. It probably doesn’t make any difference because it’s all electronic. Just make sure you have plenty of room for fan and wires. Good luck
Product Page this Question was Asked From
Progressive Dynamics 9300 Series RV Converter Charger - 12V - 45A
- Power Converter
- Converter Only
- Manual Switch
- 12V
- 45 Amps
- AC to DC
- AGM
- Lead Acid
- Lithium
- RV
- Multi-Stage Charge
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: windshield wipers
- Search Results: trailer hitch
- Search Results: gen~y hitch hitch pins and clips
- Search Results: timbren vehicle suspension
- Search Results: gen y hitch pin
- Search Results: pd9360
- Shop: Trailer Hitch
- Shop: Suspension Enhancement
- Shop: Timbren Suspension Enhancement System - Rear Axle
- Shop: TorkLift SuperHitch Magnum Trailer Hitch Receiver - Custom Fit - Class V - 2-1/2" and 2"
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Shop: Gen-Y Hitch Pin and Clip for 2-1/2" and 3" Hitches - 5/8" Diameter x 4" Span
- Shop: Timbren Front Suspension Enhancement System
- Shop: Threaded Anti-Rattle Hitch Pin Lock for etrailer Cargo Carriers - Keyed Alike
- Shop: TorkLift SuperHitch Original Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Video: Timbren Suspension Enhancement System-TFRSDE Feature Review
- Video: The Low-Down on the Timbren Suspension Enhancement System
- Search Results: maxxfan
- Video: A Closer Look at the TorkLift SuperTruss Hitch Extension
- Shop: Camper Tie-Downs
- Shop: Windshield Wiper Blades
- Q&A: Ball Mount Size Of The Voyager RV Observation Camera System
- Q&A: Will Installation of Progressive Dynamics 9300 Series Converter Charger Require Changing Wiring
- Video: Review of Progressive Dynamics RV Power Converter - Standard Charge - PD69RR
- Q&A: The PD 45amp Converter is a Little Too Tall for the Space I Want to Put it
- Q&A: Can Progressive Dynamics Converter Charge Battery that is Hooked Up to Solar Panels
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Power Converter
Richard B.
3/4/2026
I installed the PD9300 in my Scamp 13 so I could charge the lithium battery I installed. The installation went smoothly and it nicely charges the battery. The only downside is that it emits a hum while charging. I believe the hum is coming from the fan in the PD9300. I read another user installed a quiet fan near the converter and that stopped the humming.