Availability Of Replacement Rubber Springs For Timbren Axle-Less Trailer Suspension

Question

Question:

Can I get replacement rubber springs for my Timbren ASR5200501 axles?

asked by: Greg W

0

Expert Reply:

Hello Greg, thanks for reaching out. Sadly, we do not offer any replacement rubber springs for the Timbren Axle-Less Trailer Suspension. Your best bet would be to reach out directly to Timbren for that. I believe they can provide them.

The rubber springs are not typically something that needs to be replaced. What happened to yours? Normal wear and tear? Or some else?

expert reply by: Jesse M

0

Jesse M.

1/27/2026

Hey Greg, were you able to get those replacement rubber springs from Timbren? Knowing what worked could help others looking for the same parts.

Answer 1

The spring center and hub face measurements that you have are more synonymous of a 3,500 lb weight capacity which is why you are having a hard time trying to find an axle with 5,200 lb weight capacity. That said, I do have an option for you in the…

view full answer...

Answer 2

The Timbren Axle-Less Trailer Suspension System part #ASR3500S05 is indeed an excellent option to either replace an existing trailer axle or upgrading from single to tandem axles. If you were upgrading, using two axle-less kits would indeed be a walk…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Availability Of Replacement Rubber Springs For Timbren Axle-Less Trailer Suspension

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching