Can Hitch be Added to Rear of Utility Trailer
Updated 12/08/2025 | Published 11/17/2025
Question:
I have a 5 x 10 Utility Trailer with a wood floor and a metal gate/ramp. I was curious if there is a product that would allow me to add a 2 inch receiver on the back of the trailer to mount my Kuat NV Base plus two bike rack. It holds up to four bikes but I usually only carry 3 bikes. The picture underneath the trailer shows the rear underneath.
asked by: Brian C
0
Trailer Frame
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Brian, you could weld a hitch opening to the bottom of your trailer frame like with the Combo Bar part # E-9. This would give you a hitch opening that you could use with your bike rack.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Combo Bar 6" with 2" Trailer Hitch Receiver - Unpainted
- Hitch Fabrication Parts
- Receiver Tube
- 6 Inch Long
- Raw Finish
- Fits 2 Inch Hitch
- CURT
more information >
Continue Researching
- Q&A: Will EcoHitch Hidden Front Mount Trailer Hitch Fit 2026 Chevy Suburban
- Q&A: Will Fulton Tandem Trailer Fender # F008583 Fit Shoreland'r Tandem Axle Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Hitch Receiver Sizes
- Q&A: Replacement LP Gas Detector for a CCI 7770.2 / Pre Tell 22 Detector
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Replacement 12 Inch Brake Assemblies for Redline EB01-140 and EB01-145 From Dexter Axle
- Q&A: Replacement Master Cylinder Caps for Titan Brake Actuating Trailer Couplers
- Q&A: Trailer Brakes Lockup When Trailer is Connected to a 2013 Chevrolet Silverado
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Rooftop Cargo Carriers
Jameson C.
12/8/2025
Hey Brian, how did things go with welding the combo bar to your trailer frame for the bike rack? Your results could really help others looking to add a hitch receiver to a similar setup.