Looking for Replacement Stud for Dexter Vortex Wheel Hub
Updated 10/22/2025 | Published 09/21/2025
Question:
I have Dexter Vortex wheel hubs in my boat trailer. They are the 6 bolt 5.5 inch pattern. What is the correct replacement wheel stud for this hub. I know it should be a 1/2 20 stud but do not know the length or knurl size and length.
asked by: William
0
Expert Reply:
Hey William, in the past we have recommended the wheel stud part # K12WB2 for the Dexter Vortex hubs with your stud size. Check out the attached picture to verify this is same size as what you need.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Dexter 4-3/4" x 1-1/2"-20 Press-In Wheel Stud - Qty 1
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 1/2 Inch Diameter
- Drive-In Stud
- 4-3/4 Inch Long
- Dexter
more information >
Continue Researching
- Q&A: Where are the Brake Controller Wires on a 2025 Chevy Traverse?
- Q&A: How To Measure A Trailer Spindle To Find Replacement Hubs And Bearings
- Q&A: Difference Between an Idler Hub and a Hub/Drum
- Q&A: Wiring Diagram of the Replacement Hand Controller for Meyer Straight Blade Snowplow
- Q&A: When Should Trailer Wheel Bearings be Replaced
- Q&A: Replacement Trailer Wheel Studs With 1/2 inch Diameter
- Q&A: What Would Cause Wheel Studs to Break on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
Jameson C.
10/22/2025
Hey William, did the wheel stud you checked match up with your Dexter Vortex hub? Knowing how the fit turned out could help others looking for the same replacement.