Can I Drill New Mounting Holes to Install the Replacement Tongue Jack for Lippert Ground Control TT?
Updated 09/25/2025 | Published 09/14/2025
Question:
Are you able to drill and turn the tongue jack 90 degrees with the Ground Control TT system? Thank you.
asked by: Keith B
0
Expert Reply:
Hey Keith. If you're talking about drilling into your trailer's tongue then the answer is yes. You can drill new mounting holes in your trailer to install the Replacement Tongue Jack for Lippert Ground Control TT Leveling System item # LC421366 so it faces the side. If you drill into the jack mounting bracket you'll void the warranty.
What model trailer do you have?
expert reply by:
Jerred H
0
Mounting Holes
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Replacement Tongue Jack for Lippert Ground Control TT Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Assembly
- Lippert
more information >
Continue Researching
- Q&A: Availability Of Replacement Parts For Lippert 421366 Tongue Jack
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Q&A: Troubleshooting Electric Trailer Jack Not Working With Fully Charged Battery
- Q&A: Does Lippert Jack LC421366 Need to be Replaced if Gears Stopped Working
- Q&A: Looking For Lippert TT jack For Jayco Camper Lippert Part 811995
- Q&A: Replacement Electric Tongue Jack For A 2021 Jayco Eagle 312 BHOK Travel Trailer
- Q&A: How to Connect Wiring for Extend/Retract Switch for Lippert Electric Trailer Jack
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Which RV Propane Tank Size Do I Need?
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: My Trailer Hitch Doesn't Fit
Keith
9/25/2025
I meant can you take off the power head and turn it 90 degrees, not drilling new holes into the tongue steel. Thanks.