Could Rubber Grips be Added to Caliber Vehicle Ramps with Wheel Chocks # CA24AJ

Question

Question:

can you order additional rubber grip stoppers to be placed on the bottom of the ramp for additional slip protection ?

asked by: Bob

0

Expert Reply:

Hey Bob, there might be a way to add rubber grip to the Caliber Vehicle Ramps with Wheel Chocks # CA24AJ but that's not something we have info on or a recommended way to do so.

expert reply by: Jameson C

0

Jameson C.

9/2/2025

Hey Bob, did you find a way to add rubber grip to your Caliber Vehicle Ramps? I'm curious to know what worked for you, as it might help others looking for similar solutions.

Answer 1

Hey Napoleon! The perfect hitch for your 2026 Honda CR-V Hybrid Sport is the etrailer #e98848. This is a Class III hitch with a bolt-on installation and a limited lifetime warranty. It also features a matte black finish which blends well with OEM…

view full answer...

Answer 2

Hi Rob, both the etrailer hitch part #e98848 and the EcoHitch part #EH25KR will install and function properly on your 2026 CR-V Hybrid Sport Touring, so you’re not risking choosing a hitch that won’t work. Both hitches use a hidden cross tube and…

view full answer...

Answer 3

Hey Eric! The B&W Trailer Hitch #BW97BR won't cause you to lose the hands free functionality on your 2026 Honda CR-V Hybrid Sport Touring. What it will do is block the sensor right in the middle where the receiver sits. The same is true for…

view full answer...

Answer 4

Hey Matt, thanks for reaching out! The only time crossbars can be adjusted on a vehicle is when it has raised rails or multiple mounting points built into the frame. Since your 2026 Honda CR-V is only available with flush rails or a naked roof the…

view full answer...

Answer 5

I have a solution for you but there is not a direct replacement for your old Atwood unit. Instead, you can use the 2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - White #RS34FR to replace your old Atwood carbon monoxide detector, but…

view full answer...

Answer 6

Hey Erica, thanks for reaching out! Since your 2026 Honda CR-V is a Hybrid we're a bit limited on the hitch options, and you'll need to get one that does require some fascia cutting. For this, I recommend the etrailer Trailer Hitch Receiver…

view full answer...

Answer 7

Hello Richard, thanks for reaching out. The Caliber Vehicle Ramps #CA24AJ are 37-3/8" long, 13-1/8" wide and 9" tall overall. This is a very solid choice for a ramp. The are super sturdy and much lighter and easier to deal with than a…

view full answer...

Answer 8

Hey Ronald, you actually don't need to use two sets of the Caliber Vehicle Ramps part #CA24AJ. You could just put them under the outside tires and they would work great. They have more than enough capacity at 20k since most your van would weigh…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Could Rubber Grips be Added to Caliber Vehicle Ramps with Wheel Chocks # CA24AJ

Product Page this Question was Asked From

Continue Researching