Dimensions Of The Caliber Vehicle Ramps CA24AJ

Question

Question:

How high is the ramp in inches? Width? For an Rv on driveway

asked by: Richard

0

Expert Reply:

Hello Richard, thanks for reaching out. The Caliber Vehicle Ramps # CA24AJ are 37-3/8" long, 13-1/8" wide and 9" tall overall. This is a very solid choice for a ramp. The are super sturdy and much lighter and easier to deal with than a metal ramp.

expert reply by: Jesse M

0

Caliber Vehicle Ramps
(click to enlarge)

Answer 1

The RoadActive Suspension won't have as much of an impact on your unloaded ride quality as it will when towing the trailer, especially on a brand new truck with a new suspension system. However, it will make a difference, more so as your…

view full answer...

Answer 2

Thanks for the picture! I would definitely go with one of the HD kits over the 2,000 lbs RoadActive item #RAS3611 you were looking at. Which one you will need is going to depend on whether or not your 2020 Chevy Silverado 2500HD has the factory…

view full answer...

Answer 3

The best product to use to prevent sagging on your 2020 GMC Sierra HD while pulling a 42' fifth-wheel trailer is the RoadActive Suspension Custom Leaf Spring Enhancement Kit #RAS3611 (2,000 pound weight capacity) or the #RAS3611-HD (3,000 pound…

view full answer...

Answer 4

I would be happy to explain the differences. The RoadActive Suspension Kit #RAS3611 has the standard capacity of 2,000 lbs. The #RAS3611-HD and #RAS3611-CHD have a 3,000 lb capacity since they are the heavy duty versions. The #RAS3611-HD is designed…

view full answer...

Answer 5

I would not recommend the part #RAS3611-HD for your 2017 Nissan Titan XD. This kit is designed for heavier duty vehicles so it would make your suspension harsh. The part #RAS3611 is the correct kit you'd want. It will give you the suspension…

view full answer...

Answer 6

Hi John; I don't know exactly what is on your 2014 Thor Freedom Elite 28H but the Vesper Steel Dual Trailer Wheel #MX89FR matches everything you gave me. The only thing you would need to do is check the offset and see if it matches at…

view full answer...

Answer 7

Hi Thien, From what I saw a 2017 Ford E450 chassis does use the same 16x6 wheel with an 8 on 6-1/2" bolt pattern, so the correct fit is the Steel Dual Wheel with Offset - 16" x 6" Rim - 8 on 6.5 - 4.75" Pilot - Silver #AM83NR.…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Dave, the wiring that comes with the etrailer RV Solar Panel Kit part #e59FV is 7.5 meters long. I attached a diagram that shows how multiple panels attach to the controller. This is compatible with lithium batteries too. Is this first time with…

view full answer...

Dimensions Of The Caliber Vehicle Ramps CA24AJ

Product Page this Question was Asked From

Continue Researching