Can Pitch Awning Arms be Swapped to Flat Awning

Question

Question:

LCI 2000 Series RV Awning Pitch Arm lc93bx. Is it possible to replace the pair with the style that is hinged in the center and you pull down to pitch?

asked by: William P

0

Expert Reply:

Hey William, it sounds like you are wanting to convert to a flat style awning instead which you can do by swapping both of your arms to that style with the black part #LC281152. Are you current awning arms black or white?

expert reply by: Jameson C

0

Jameson C.

9/2/2025

Hey William, did you get a chance to check the color of your current awning arms? If you're still looking for a solution, I'm happy to help.

Answer 1

Hey Lester. The 2016 Grand Design Reflection 337RLS uses a Schwintek system. The motor should be located at the top of the vertical column on either side of the slide-out, which is accessible from the outside. You'll need to pull back the rubber…

view full answer...

Answer 2

Hey, Chris. After doing some research and checking with Lippert, It looks like the only replacement part they have for the Venture Actuator and High Speed Slide-Out Motor, part #LC168956 is the motor itself, part #LC295380. In my searching It looks…

view full answer...

Answer 3

Hey Matt! I spoke with my contact at Lippert and they're needing some photos of the motor, including any and all data tags on the motor itself. They aren't able to find anything with the part number 080300994 that you sent me. You can send…

view full answer...

Answer 4

Hello Frank, thanks for reaching out. At this time we only offer two lift assist struts for the Lippert Solid Steps: - Replacement Lift Assist Strut for Lippert SolidStep Triple RV Steps - Narrow Door Frames #LC67UD (for Lippert SolidStep 3-step RV…

view full answer...

Answer 5

Part number B10E-21 corresponds to Electric Trailer Brake Assembly #AKEBRK-35L. This is the drivers side assembly. Part number B10E-22 corresponds to Electric Trailer Brake Assembly #AKEBRK-35R. This is the passenger side assembly.

view full answer...

Answer 6

The outside diameter of the outer tube of the Lippert Components Venture Actuator and High Speed Slide-Out Motor #LC168956 that you referenced is 2 inches. I confirmed this with Lippert and attached a dimensional picture of this for you to check out…

view full answer...

Answer 7

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.

view full answer...

Can Pitch Awning Arms be Swapped to Flat Awning

Product Page this Question was Asked From

Continue Researching