How To Know If You Have Clearance On Trailer's A Frame For MORryde WDH Storage Brackets

Updated 08/05/2025 | Published 07/30/2025

Products Featured in This Question

MORryde EzStor - Bolt-On Storage Bracket for Weight Distribution Hitches

(2)

$141.68

MORryde EzStor Lite - Removable Storage Bracket for Weight Distribution Hitches

(12)

$71.99

Question:

How high does the bracket sit above the A-frame? Clearance is tight near my LP cover.

asked by: Theresa

Expert Reply:

From the top of your frame to the highest point of the bracket, you’re looking at just under 5-1/2 inches. That usually clears LP tank covers, but if yours flares out low, you might need to offset it rearward slightly.

The full dimensions of the MORryde EzStor - Bolt-On Storage Bracket for WDH # MR62ZV are
-6-3/8" tall
-22-1/4" wide
-17-1/2" deep

As long as you have room for this, and also a little bit more room on the inside to clear the trunnion bars as seen in the attached pics, you'll be okay. If you have batteries in the middle rack you shouldn't have an issue, unless they are basically touching the trailer's A-frame. If they are, you may be better off with a more temporary storage solution that can be moved around on you trailer frame: MORryde EzStor Lite - Removable Storage Bracket for WDH # MR72ZV. This also allows you to store the trunnion bars on the outside, parallel to the frame, instead of overhanding to the inside.

Let me know what you think!

expert reply by: Andrew N

MORryde MR62ZV installed
(click to enlarge)

Theresa

8/5/2025

Thanks! Is this something I can install myself, or would it be better to have a shop do it?

Andrew N.

8/5/2025

@Theresa You can absolutely install the # MR62ZV yourself. It just bolts onto the A-frame; no drilling required. If you’ve got a socket set and a level surface to work on, you’ll be good to go. Most folks knock it out in a few minutes. The removable one # MR72ZV just sets in place though, so that one wouldn't take time to install at all!