Will etrailer Boat Winch Need New Mounting Bracket Holes Drilled when Replacing Shelby
Updated 09/29/2025 | Published 05/08/2025
Question:
I have an old Shelby winch. Do I need to drill new holes for the e75VV or what?
asked by: Ben H
0
Expert Reply:
Hey Ben, no you would not need to drill new holes in your winch mount to install the etrailer boat winch part # e75VV. This has the standard winch mounting bracket design that is slotted so it will work great in place of your Shelby. How did you like the Shelby?
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Boat Trailer Winch w/ 23' Strap - 10-1/2" Handle - 1,400 lbs
- Trailer Winch
- Standard Hand Winch
- Boat Trailer Winch
- 1001 - 2000 lbs
- Ratcheting Hand Crank
- Single Speed Winch
- Polyester Strap
- etrailer
more information >
Continue Researching
- Q&A: etrailer Winch for Boat Trailer that Tows Ski Nautique 206
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Q&A: Base Dimensions and Mounting Hole Location of MaxxTow MaxxHaul Hand Winch # MT50156
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Correct Replacement for 10 Inch x 1-3/4 Inch Braking Assemblies
- Q&A: Replacement Trailer Suspension Parts for Trailer with 2 Square Axle
- Q&A: Recommended Replacement Seal For A Tri Tec T-23972 Seal
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Replacement Hub and Drum Assemblies for 2002 Escort Boat Trailer
- Article: Trailer Lighting Requirements
- Article: How to Determine Tire/Wheel Diameter
- Article: Trailer Wiring Diagrams
- Article: How Much Does a Boat and Trailer Weigh?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
Jameson C.
9/29/2025
Hey Ben, did the etrailer boat winch fit well on your mount without needing any new holes? I'm curious to know how it worked out for you, as it could help others with similar setups.